This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
Regulatory Compliance
As of the date of manufacture, the DM-RX1-1G has been tested and found to comply with specifications for CE
marking and standards per EMC and Radiocommunications Compliance Labelling.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Industry Canada (IC) Compliance Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device includes an aggregation of separate independent works that are each generally copyrighted by Crestron Electronics, Inc., with all rights
reserved. One of those independent works, Linux Bridge Project, is copyrighted under the GNU GENERAL PUBLIC LICENSE, Version2,
reproduced in “GNU General Public License” on page 28, where the corresponding source code is available at: ftp://ftp.crestron.com/gpl.
Dolby and Dolby Digital are registered trademarks of Dolby Laboratories. DTS is a registered trademark and the DTS logos, symbol, and DTS-HD Master Audio are
trademarks of DTS, Inc. HDMI is a trademark or registered trademark of HDMI Licensing LLC in the United States and other countries.
GNU General Public License ..................................................................................................28
Operations & Installation Guide – DOC. 6969B Contents • i
Crestron DM-RX1-1G DigitalMedia™ CAT Receiver
Wall Plate DigitalMedia CAT
Receiver: DM-RX1-1G
Introduction
The DM-RX1-1G which is part of the Crestron® DM® product line, is a
DigitalMedia™ CAT receiver that installs in a single-gang electrical box
or floor box. It provides one HDMI
display or audio processor as part of a complete DigitalMedia system.
®
output to feed a high definition
Features and Functions
• DigitalMedia receiver and HDMI display interface
• DM CAT input supports up to 425 feet (~130 meters) cable
length
• Compact 1-gang wall mount design
• Available colors include black or white
• Fits in a floor box
• Provides a single HDMI/DVI display output
• Affords single-wire connection from a DM switcher (sold
separately)
• Supports 3D HDTV signals
1
2
1. For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to two DM
Repeaters (Model DM-DR, sold separately) may be required. Refer to the
Crestron DigitalMedia Design Guide (Doc. 4789) for complete wiring guidelines.
It is available from the Crestron Web site (www.crestron.com/digitalmedia
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI
signal. CBL-HD-DVI interface cable available separately.
As the leader in HDMI and control system technologies, Crestron has
developed DigitalMedia, the first complete HD AV distribution system
that takes HDMI to a higher level, and allows virtually any mix of AV
sources to be distributed throughout the home, office, school, or virtually
any other facility.
DigitalMedia distributes uncompressed digital video and audio signals
several hundred feet using DM cable
1
. DigitalMedia thoughtfully
manages all of the different signals and devices, matching each source’s
output to the capabilities of the selected display(s) without using scaling
or compression. Every signal is preserved in its native video resolution
and audio format, ensuring a pure, lossless signal path throughout.
Multimedia Display Interface
A single HDMI digital AV output port is provided on the DM-RX1-1G,
handling 1080p60 HDTV with HDCP and multi-channel HD lossless
audio, all through a single connection. The HDMI output can also handle
WUXGA computer resolutions, and supports DVI signals using an
appropriate adapter or interface cable
The DM-RX1-1G connects to the DM CAT output of a DM-MD series
switcher to feed a high-definition display device or other equipment up to
425 feet (~130 meters)
1
away. Multiple DM-RX1-1Gs may be installed to
feed multiple displays, all fed from a central DM-MD series switcher.
2
.
Simple Wall Mount Design
The DM-RX1-1G is designed to be wall mounted using a standard
electrical box or plaster ring, or attached to a rack rail in the back of an
equipment cabinet. It also fits select floor boxes. The DM cable is
terminated to the rear of the receiver using screw terminals.
1. For DigitalMedia CAT wiring, use DM-CBL DigitalMedia Cable. Up to two DM
Repeaters (Model DM-DR, sold separately) may be required. Refer to the
Crestron DigitalMedia Design Guide (Doc. 4789) for complete wiring guidelines.
2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI
signal. CBL-HD-DVI interface cable available separately.
* HDMI requires an appropriate adapter or interface cable to accommodate a DVI
signal. CBL-HD-DVI interface cable available separately.
NOTE: Crestron software and any files on the Web site are for
authorized Crestron dealers and Crestron Authorized Independent
Programmers (CAIP) only. New users may be required to register to
obtain access to certain areas of the site (including the FTP site).