DM NVX™ device
DM-NVX-D80-IOAV
DM NVX™ 4K60 4:4:4 HDR Network AV OPS Decoder
The Crestron® DM-NVX-D80-IOAV is a compact DM NVX™ decoder that is compatible with the
Intel® Open Pluggable Specification (OPS). Equipped with an OPS port, the DM-NVX-D80-IOAV
is designed for installation into the OPS slot of an OPS-supported display.
Check the Box
Item Qty
DM-NVX-D80-IOAV 1
Install the Device
The OPS port of the DM-NVX-D80-IOAV is located on the rear panel of the device. When the
DM-NVX-D80-IOAV is installed into the OPS slot of a display, the OPS port of the
DM-NVX-D80-IOAV connects to the OPS port of the display.
OPS Port of DM-NVX-D80-IOAV (Rear Panel)
OPS port
To install the DM-NVX-D80-IOAV into an OPS slot of a display:
NOTE: The display shown below is for illustrative purposes only. Your display may dier from
the one shown below. If desired, refer to the OPS device installation instructions in the display
documentation in addition to the instructions below.
1. Disconnect mains power from the display. The DM-NVX-D80-IOAV is not hot-swappable.
2. Remove the OPS slot cover on the display by loosening the two slot cover screws.
Retain the screws for use in step 4 below.
3. With the fan of the DM-NVX-D80-IOAV facing you or the display (display dependent),
insert the DM-NVX-D80-IOAV into the OPS slot until the device clicks into place.
4. Using the two screws removed in step 2 and the two mounting holes of the
DM-NVX-D80-IOAV, secure the DM-NVX-D80-IOAV in the slot.
5. Reconnect mains power to the display.
6. Verify that the input source of the display is set to use the DM-NVX-D80-IOAV in the
OPS slot.
Installation of DM-NVX-D80-IOAV into OPS Slot of Display
Sample OPS display
Connect the Device
No external HDMI®, USB, RS-232, and power cables are required to connect to the
DM-NVX-D80-IOAV. Console and Ethernet port connections are made to the front panel as
shown below.
Front Panel Connections
To
computer
SETUP
button
and LED
PWR
LED
RESET
button
OL
LED
NV
LED
:
100BASE-TX/
1000BASE-T to
Ethernet switch
or other
LED Indicators
Refer to the following table for information about the LED indicators on the device.
LED Indicator Color Meaning
PWR Amber Power is being applied to the device via the OPS-
Green Power is being applied to the device via the OPS-
SETUP Red The SETUP button is pressed.
OL Green The device is online with a control system.
NV Green The device is receiving and decoding network video.
LAN Green An Ethernet link is established.
Flashing amber Data activity is occurring on the Ethernet link.
supported display. The device is booting.
supported display. The device is operational.
Configure the Device
Congure the device using the web interface. To access the web interface, open a web browser
and then go to the IP address of the device.
NOTE: By default, the IP address of a DM NVX device is assigned by a DHCP server on the
network. If a DHCP server does not exist on the network, the IP address defaults to a link-local
address in the 169.254. xxx.xxx range. Refer to RFC 3927 for detailed information about link-local
addressing. To display the IP address on the connected display, press the SETUP button on the
front panel of the device.
To log in to the web inter face, enter the user name and password. The default user name and
password are both admin.
Upgrade the Firmware
Before using the device, upgrade the rmware. The latest rmware can be downloaded from the
DM-NVX-D80-IOAV product page on the Crestron website (www.crestron.com).
Connect to the Crestron XiO Cloud Service
The Crestron XiO Cloud™ ser vice allows supported Crestron devices across an enterprise to be
managed and congured from one central and secure location in the cloud. Supported devices
are precongured to connect to the service. Use of the service requires a registered Crestron
XiO Cloud account.
To connect the device to the Crestron XiO Cloud service:
1. Record the MAC address and serial number that are labeled on the shipping box or front
panel of the device. The MAC address and serial number are required in order to add the
device to the Crestron XiO Cloud environment.
2. Do either of the following:
• If you have a Crestron XiO Cloud account, go to https://portal.crestron.io to access the
Crestron XiO Cloud service.
• If you do not have a Crestron XiO Cloud account, go to www.crestron.com/xiocloud to
register for an account.
For detailed information about using the Crestron XiO Cloud service, refer to the Crestron XiO
Cloud Ser vice User Guide (Doc. 8214) at www.crestron.com/manuals.
Additional Information
Scan or click the QR code for detailed product information.
DM-NVX-D80-IOAV
(2) Mounting holes for attachment to
OPS slot of display (slot cover screws of
display not shown)
DM-NVX-D80-IOAV
Compliance and Legal
Original Instructions: The U. S. Engl ish ver sion of t his document i s the original i nstr ucti ons. A ll othe r langu ages ar e a translatio n
of the original instructions.
Regulatory Model: M1848001
Federal Communications Commission (FCC) Compliance Statement
This device com plies w ith par t 15 of the FCC Rules. Ope ratio n is subject to the following conditi ons: (1) This device may not
cause ha rmful interf erence and (2) t his device must accept any inter feren ce recei ved, in cluding inter ference that may cause
undesired operation.
CAUTION: Changes or m odication s not exp ressl y appro ved by the m anufa cture r respo nsible for com plian ce could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested an d found to comply with th e limit s for a Cla ss B digi tal device, pur suant to part 1 5
of the FCC R ules. These l imit s are designed to provid e reaso nable protec tion a gains t harmf ul interfere nce in a residential
installation. This equip ment ge nerates, uses and can radiate radio fre quency energy and, if not installed and used in
accordance wit h the instructions, may cause ha rmful interf erence to radio co mmunications. However, there i s no guarantee
that interfe rence will not occur in a pa rtic ular install ation . If this equipment does cause h armfu l inter feren ce to radio or
television re cepti on, whi ch can be d etermined by tu rning t he equi pment o and on, t he user is encou raged t o try to correc t the
inter ference by one or m ore of th e follow ing measures :
• Reori ent or relocate t he rece iving antenn a.
• Incre ase the separ ation b etwe en the equipment and re ceiver.
• Connect th e equip ment int o an outl et on a circuit di erent from that to which t he rece iver is co nnec ted.
• Consu lt the dealer o r an expe rienced radio/T V techn ician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
As of th e date of ma nufac ture, t he prod uct ha s been tested a nd foun d to compl y with s peci catio ns for CE m arkin g.
The Waste Elec trical & Electronic Equipment (WEEE) dir ecti ve mark ing on a produc t indicates that it should not b e dispo sed
of with general waste. Inste ad, you are encou raged to reuse or r ecycl e the pro duct i n accord ance with Dire ctiv e 2012 /19/EU of
the Euro pean Un ion. Proper di spos al of this produc t will h elp prevent pot ential negat ive ee cts o n the env ironm ent and human
healt h, whic h could ot her wise be caused by inappropriate waste handl ing. Penalti es may be applicable fo r incorrect di sposal
of this wa ste, in a ccordance with your nat ional legis latio n. For informa tion ab out rec yclin g this pr oduc t, ple ase contact your
waste dispos al ser vice, your original distri butor, or Cre stron.
The pro duct warrant y can be fo und at www.crestron.com/warranty.
The specic p atent s that cover Cres tron p roduc ts are l isted a t www.crestron.com/legal/patents.
Certain Cres tron pr oduc ts cont ain ope n source s oft ware. Fo r spec ic informat ion, pl ease v isit www.crestron.com/opensource.
Crestron, the Crest ron log o, Crestron Xi O Cloud , and DM NVX are either t radem arks or regis tered trademarks of Crestron
Electronic s, Inc. in the United States an d/or other countr ies. H DMI is either a t radem ark or re giste red tra demar k of HDM I
Licensing LLC i n the Uni ted Stat es and/or ot her countries. Inte l is eith er a trad emark o r regis tered t radem ark of In tel
Corpo ratio n in the Un ited Sta tes and/or other countries. Ot her tra demar ks, re giste red tra demar ks, an d trade n ames may be
used in t his doc ument to refer to ei ther t he enti ties cl aiming the mar ks and names or their products. Cre stron disclaims any
proprietar y intere st in th e marks and names of others. Crestro n is not respons ible for errors in typ ograp hy or phot ography.
©2019 Crestro n Elec tronics, In c.
Crestron Electronics, Inc.
15 Volvo Drive, Ro cklei gh, NJ 076 47
Tel: 888.CRESTRON
Fax: 201 .767.7576
www.crestron.com
Quick Start - Do c. 852 6A
Speci cati ons sub ject t o
change without notice.
(205 4410)
10/25/19
Loading...