Creston PW-1215WU INSTALLATION

Crestron PW-1215WU
Power Pack

Installation Guide

This document was prepared by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

Regulatory Compliance

This product is Listed to applicable UL Standards and requirements by Underwriters
Laboratories Inc.

As of the date of manufacture, the PW-1215WU has been tested and found to comply
with specifications for CE marking, standards per EMC and Radiocommunications
Compliance Labelling and Japan electrical appliance and material safety law.

PS

E

The PW-1215WU complies with se ction 301 of the Energy Independence and Securities
Act (EISA).

Energy Efficiency Level

IV

All brand names, product names and trademarks are the property of their respective owners.

©2010 Crestron Electronics, Inc.

Description

The PW-1215WU is a regulated universal LPS (limited power source)
power pack that is used to power a 12 Volt Crestron
standard AC receptacle (100-240 VAC, 50-60 Hz). It is designed for
indoor use only.

CAUTION: Connect this power pack only to a Crestron device that is
rated at 12 Volts (regulated) and no more than 1.5 Amps. Plugging this
power pack into a Crestron device that has a different rating could
damage the device or the power pack.

®

product from a

Specifications

Specifications for the PW-1215WU are listed in the following table.

PW-1215WU Specifications

SPECIFICATION DETAILS

Power

Input
Output

Cable Length 6 feet (~1.8 meters)
Environmental

Temperature
Humidity

Dimensions

Height
Width
Depth

Weight 5 oz (144 g)

100-240 Volts AC, 50/60 Hz
12 Volts DC @ 1.5 Amps, regulated,
using male barrel (5.5 x 2.5 mm)
connector

41° to 104° F (5° to 40° C)
10% to 90% RH (non-condensing)

2.90 in (74 mm)

1.72 in (44 mm)

1.38 in (35 mm) without adapter

PW-1215WU Power Pack Adapter Insert Set

North America
Japan

Europe
South America

PW-1215WU Power Pack Hookup

AC

Receptacle

PW-1215WU

Power Pack

Australia
China

United Kingdom
Hong Kong
Singapore

Crestron

Device

Setup

Complete the following steps to properly set up and connect the power
pack.

1. Slide the thumb switch on the PW-1215WU downward and
remove the protective insert from the unit by pulling the
bottom part toward you, then sliding it downward to release
the tab.

2. Select the proper adapter insert from the set of four.

3. Slide the thumb switch on the PW-1215WU downward and
install the adapter insert into the unit, top part first to engage
the tab, then press the bottom part into place.

4. Attach the barrel connector to the device to be powered.

5. Insert the power pack into an active AC receptacle.

PW-1215WU Power Pack (Shown With and Without Protective Insert)

Please remove it before use

Further Inquiries

If you cannot locate specific information or have questions after
reviewing this guide, please take advantage of Crestron’s award
winning curstomer service team by calling Crestron at
1-888-CRESTRON [1-888-273-7876].

You can also log onto the online help section of the Crestron website
(www.crestron.com/onlinehelp) to ask questions about Crestron
products. First time users will need to establish a user account to fully
benefit from all available features.

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange or service without prior authorization from

CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized
CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request
an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the
problem, name and phone number of contact person, RMA number and return address.

2. Products may be returned for credit, exchange or service with a CRESTRON Return

Merchandise Authorization (RMA) number. Authorized returns must be shipped freight prepaid to
CRESTRON, 6 Volvo Drive, Rockleigh, N.J. or its authorized subsidiaries, with RMA number
clearly marked on the outside of all cartons. Shipments arriving freight collect or without an RMA
number shall be subject to refusal. CRESTRON reserves the right in its sole and absolute
discretion to charge a 15% restocking fee plus shipping costs on any products returned with an
RMA.

3. Return freight charges following repair of items under warranty shall be paid by CRESTRON,

shipping by standard ground carrier. In the event repairs are found to be non-warranty, return
freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in
materials and workmanship under normal use for a period of three (3) years from the date of purchase
from CRESTRON, with the following exceptions: disk drives and any other moving or rotating
mechanical parts, pan/tilt heads and power supplies are covered for a period of one (1) year;
touchscreen display and overlay components are covered for 90 days; batteries and incandescent lamps
are not covered.

This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON
dealer. Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty,
if any.

CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any
application other than that for which it was intended or if it has been subjected to misuse, accidental
damage, modification or improper installation procedures. Furthermore, this warranty does not cover any
product that has had the serial number altered, defaced or removed.

This warranty shall be the sole and exclusive remedy to the original purchaser. In no event shall
CRESTRON be liable for incidental or consequential damages of any kind (property or economic
damages inclusive) arising from the sale or use of this equipment. CRESTRON is not liable for any claim
made by a third party or made by the purchaser for a third party.

CRESTRON shall, at its option, repair or replace any product found defective, without charge for parts or
labor. Repaired or replaced equipment and parts supplied under this warranty shall be covered only by
the unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or
implied, nor authorizes any other party to offer any warranty, including any implied warranties of
merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law
are limited to the terms of this limited warranty. This warranty statement supersedes all previous
warranties.

Trademark Information

All brand names, product names and trademarks are the sole property of their respective owners.
Windows is a registered trademark of Microsoft Corporation. Windows 95/98/Me/XP/Vista/7 and
Windows NT/2000 are trademarks of Microsoft Corporation.

Crestron Electronics, Inc. Installation Guide - DOC. 6971A

15 Volvo Drive Rockleigh, NJ 07647 (2027249)
Tel: 888.CRESTRON 08.10
Fax: [phone] Specifications subject to
www.crestron.com change without notice.