Cres Cor R-171-SUA-20 User Manual

INSULATED

®

CHILLTEMP

REFRIGERATED CABINET

MODEL R-171-SUA-20

FEATURES AND BENEFITS:

• Fully insulated double capacity mobile ChillTemp®
refrigerated cabinet for holding food and beverages at
serving temperature.

• Forced air system provides even distribution of cold

air; cabinet maintains temperatures from 33˚F (.5˚ C)
to 40˚F (4.5˚ C). Automatically defrosts.

• 1/3 horsepower compressor with automatic
overload reset. R134a refrigerant for environmental
compatibility.

JOB:

ITEM NO:

• Stainless steel construction throughout for ease of
cleaning. One piece extended base protects cabinet
body.

• Push/pull handles on both sides prevent damage to
walls; allows easy maneuvering.

• Self-closing insulated doors prevent temperature loss.
Magnetic door gaskets for proper seal.

• Safety-conscious anti-microbial handles protect
against spreading germs.

• Full length extruded door handles for “easy open”;

positive catch (available in USA only) secures door

during transport.

• Generous 39-cubic foot interior.

• Twenty sets of chrome plated wire universal angles
accommodate a large variety of pan sizes on
adjustable 1-1/2" centers.

• Heavy duty 6" casters, two rigid and two swivel with
brakes. Provides mobility when fully loaded.

• One piece welded base with perimeter bumper
provides solid foundation to support heavy loads.

R-171-SUA-20

®

SANITATION

NSF/ANSI 4

ACCESSORIES and OPTIONS
(Available at extra cost):

q Extra Universal Angles

q Transport Angles

q Drop Down Pull Handle

q Menu Card Holder

q Polyurethane Casters

q Magnetic Door Latch (USA only)

q 240 Volt Service

q Digital Thermometer

q Interior for (56) 18" x 26" pans

See page K-2 for accessory details.

C US

®

5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]

www.crescor.com

Page K-2

Dec., 2014

R-171-SUA-20

5-1/16

4-1/2

12

B

A

ON

OFF

R

BA

C

DETAIL OF

PAN SLIDE

CRES COR

MODEL NO.

ANGLES

R-171-SUA-20

NOTES: 1. Pan sizes 22" x 20" (560 x 510) Roast & Bake Pans, 10" x 20" (255 x 510) Roast & Bake Pans, 18" x 26" (460 x 660)

ALL CONSTRUCTION IS RIVETED, WELDED AND FINISHED.

Bun Pans, 14" x 18" (355 x 460) Service Trays, 12" x 20" (305 x 510) Steam Table Pans.

Refer to Pan Size Chart at end of section.

2. When ordering bumpers, add 2" to overall dimensions.

PAN DIM "A" DIM "B" DIM "C" INSIDE DIMENSIONS

CAP/

20

SETS

SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT

SEE NOTE

BELOW

IN 62 35-1/2 74-3/4 22 27-1/2 46-3/4 LBS 580

MM 1575 905 1900 560 700 1190 KG 263

2

G

W

5-15P

WEIGHT

ACT.

CABINET:

• Body: 22 ga. stainless steel.

• Reinforcement: Internal framework of 16 ga. stainless steel.

• Insulation: Fiberglass, thermal conductivity (K factor) is

.23 at 75˚F. 1-1/2" in doors, base, top; 2" in sidewalls.

• Push/pull handles (2).

• Interior coved corners.

BASE:

• One piece construction, .125 aluminum.

• Casters: 6" dia., modulus tires, 2" wide, load cap. 450 lbs.

each, temp. range -45˚/+180˚F. Zerk ttings. Two rigid and

two swivel casters with brakes.

• Perimeter bumper: 1 x 1 gray non-marking rubber.

DOORS:

• Formed 22 ga. stainless steel.

• Extruded handles.

• Transport latches.

• Hinges: Heavy duty chrome plated steel.

• Gaskets: Perimeter type, magnetic Santoprene.

• Pan stops: Embossed.

PAN SLIDES:

• Wire angles (.306 dia.), nickel chrome plated steel,

mounted on lift-off posts.

• Spaced on 4-1/2" centers; adjustable on 1-1/2" centers.

ELECTRICAL COMPONENTS:

• Thermostat: Pre-set to 38˚ F (3.3˚ C).

• Pilot light.

• Switch.

• Power cord: Permanent, 10 ft., 14/3 ga. with molded plug.

• Compressor: 1/3 h.p.

• Condensate evaporator: Electrical.

• R134a refrigerant.

• Vent fan

POWER REQUIREMENTS:

• 120 Volts, 60 Hz., single phase, 15 Amp. service.

SHORT FORM SPECIFICATIONS

Cres Cor Refrigerated Cabinet Model R-171-SUA-20.
Cabinet 22 ga. stainless steel; stainless steel internal

frame. (20) sets of wire universal angles for multiple

pan sizes, adjustable spacing every 1-1/2". Doors, 22
ga. stainless steel. Fiberglass insulation in sides 2";
doors, base, top 1-1/2". Interior coved corners. 1/3
h.p. compressor, 120 Volts. One piece insulated base,

.125 aluminum. 6" casters, (2) rigid and (2) swivel with
brakes, Zerk ttings. Load capacity 450 lbs. each.

Perimeter bumper. 2-Year Parts / 1-Year Labor warranty.
Provide the following accessories: ______ ______

______ . CSA-US/C, CSA to NSF7 listed.

In line with its policy to continually improve its products,

5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]

www.crescor.com

© Crescent Metal Products, Inc. 2011 All rights reserved. Litho in U.S.A.

CRES COR reserves the right to change materials and

specications without notice.