Page 1
Series R-171-S
Refrigerated Cabinets
FL-2314-J
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
for Cres Cor Refrigerated Cabinets,
Model R-171-S Series
Model No. Volts Amps Hertz Phase NEMA
R171SUA10J1
R171S1828J1
Note: The above model numbers are basic models. They may be followed by letters: M,
L, or ending with S.
100 ____ 60 1 5-15P
Rev. 1 (7/07)
Page 1 of 4
CONTROL PANEL
HOW TO INSTALL THE CABINET:
Remove all packing material from inside the
1.
cabinet.
INSTALL ALL ANGLES BEFORE UNIT IS
2.
TURNED ON
Allow enough clearance around cabinet for air
3.
fl ow.
HOW TO OPERATE:
Plug cord into proper wall outlet.
1.
Turn the power switch to “ON”. Light will come
2.
on and compressor will start.
Listen closely for the compressor. It will be slightly
loud at fi rst, then quiet down.
HOW TO OPERATE (Continued):
If you do not hear the compressor running, turn power
switch to “OFF” right away. See “Troubleshooting”
(page 3).
3. Pre-chill the cabinet for approximately 40 minutes
or until the temperature reaches approximately 3°C
(38°F). Load the food.
DO NOT PUT HOT FOOD INTO COLD
CABINET!
TO SHUT UNIT OFF:
Turn power switch to “OFF”.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Page 2
Series R-171-S
Refrigerated Cabinets
FL-2314-J
Rev. 1 (7/07)
Page 2 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
for Cres Cor Refrigerated Cabinets,
Model R-171-S Series
HOW TO REVERSE DOOR HARDWARE FOR OPPOSITE HAND:
(Single Door Cabinet ONLY)
Remove hinge covers with a screwdriver.
1.
Open door and lift up to remove door from cabinet.
2.
Unscrew and re-mount the hinges and latch strike to the opposite
3.
sides of the cabinet.
Remove the door hinges and the door latch. Turn hinges and handle
4.
over and remount in the same holes.
Remove plastic cam from each hinge, rotate cam 180° with “V”
5.
groove on cam toward inside of cabinet. Reseat cam into hinge.
Plug all the extra holes with screws.
6.
Put door onto cabinet and adjust as necessary.
7.
Snap on hinge covers..
8.
HOW TO CLEAN THE CABINET:
BEFORE cleaning
WARNING
Unplug cord from wall.
1.
Do NOT hose cabinet with water.
2.
Do NOT get water into bottom compartment.
3.
Do NOT use abrasives or harsh chemicals.
4.
the cabinet:
■ Wipe up spills as soon as possible.
■ Clean regularly to avoid heavy dirt build-up.
Soil Cleaner Method
Soap, Ammonia, or mild
*detergent and water.
Mild abrasive made for
stainless steel.
Chemical oven cleaner for
stainless steel.
Vinegar
CABINET
Inside
and
Outside
(Stainless Steel)
ROUTINE CLEANING
STUBBORN SPOTS
AND STAINS
GREASE, OIL
HARD WATER
SPOTS & SCALE
*Mild detergents include soaps and non-abrasive cleaners.
Cleaning Hints:
Use the mildest cleaning procedure that will do the
1.
job.
Always run in the direction of polish lines to avoid
2.
scratching the surface.
Use only a soft cloth, sponge, fi brous brushes,
3.
plastic or stainless steel pads for cleaning and
scouring.
4.
Rinse thoroughly with fresh water after every
cleaning operation.
5.
Always wipe dry to avoid water marks.
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
1. Apply with damp sponge or cloth.
2. Rub lightly.
Follow oven cleaner manufacturer’s
directions.
1. Swab or wipe with cloth.
2. Rinse and dry.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Page 3
Series R-171-S
Refrigerated Cabinets
FL-2314-J
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
for Cres Cor Refrigerated Cabinets,
Model R-171-S Series
MAINTENANCE:
HOW TO CHARGE AND SERVICE THE REFRIGERATION SYSTEM
Note: The refrigerator is shipped fully charged.
The high-side pressure should be approximately _____ PSI;
low pressure should be approximately _____ PSI at 75° F (24° C) room temperature.
The charge should be _____ ounces of R134a.
Service valves are located on the condenser/compressor assembly.
TROUBLE-SHOOTING GUIDE
Unit Condition:
Unit is plugged in. Switch is ON.
Rev. 1 (7/07)
Page 3 of 4
Failure Probable Cause
1. Power light off 1. Power Cord
2. Compressor off 2. Power supply down
3. Evaporator fan on, Power
light on and Compressor off
4. Compressor on and cabinet
not cooling
5. Compressor starts and stops;
cabinet not cooling
6. Noisy compressor 6a. Low charge
NOTES:
3a. Thermostat defective
3b. Defective start relay (compressor)
4a. Low charge
4b. Frost build-up on evaporator coil
4c. Evaporator fan defective
4d. Thermostat defective
5a. Low Charge
5b. Faulty start capacitor (compressor)
5c. Faulty start relay (compressor)
6b. Defective
1. Thermostat is pre-set at approximately 3°C (38°F). Temperature adjustment can only be made by a Service Agency.
2 For replacement of the electrical parts, refer to our list of authorized service centers (FL-1400).
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Page 4
Series R-171-S
Refrigerated Cabinets
FL-2314-J
Rev. 1 (7/07)
Page 4 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
for Cres Cor Refrigerated Cabinets,
Model R-171-S Series
REPLACEMENT PARTS: CABINET PARTS:
PART DESCRIPTION 100V PART DESCRIPTION PART NO.
Condenser/Compressor Assembly Caster, Swivel, with Brake 0569-306-B
Evaporator Assembly 1416-068-K Caster, Swivel 0569-306
Valve, Thermal expansion 0854-042-K1 Door Latch 1006-122-01-K
Power Cord 0810-171-K Door Strike 1006-122-02-K
Power Switch 0808-116 Hinge Kit 0519-087-K
Power Light 0766-094 Gasket, Door 0861-261
Thermostat, Cold control 0845-043-K Post, Angle slide 0696-237
Thermometer - digital, °C 5238-036-K1 Angle Slide 0621-281-K
Transformer
Terminal Block 0852-091
Heater, Condensate pan 0811-193
Receptacle 0713-057
(used with digital thermometer) 0769-159 Condensate Pan 1419-056
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
Loading...