Page 1
5925 Heisley Road • Mentor, OH 44060-1833
877/CRES COR (273-7267) • 440/350-1100
Fax: 440/350-7267 • www.crescor.com
for PULL-DOWN INFRA-RED MODELS IFW-63 SERIES
INSTALLATION INSTRUCTIONS
ELECTRICAL SPECIFICATIONS:
• 120 Volts; 250 Watts; 2 Amps.
• 240 Volts; 275 Watts; 1 Amp.
UL AND CSA REQUIRE:
• Wires of warmer are to be connected to
75°C wire.
• Wires to be installed with conduit
• Warmers are not to be installed closer
than 1” from a wall.
• Warmers cannot be closer than 16”
above a combustible surface
HOW TO INSTALL: (See Figure)
NOTE: Outlet box (7) and screws (5) are to be
furnished by customer.
1. Pull canopy (2) down over coil cord.
2. Attach ground wire from the ceiling to
the “GND” hold in the plate (4) with
screws (6).
3. Wire the warmer leads to the outlet box
(7) with screws (5).
4. Attach plate (4) to the outlet box (7) with
screws (5).
Infra-red Lamps
IFW 63 Series
Rev. 5 (7/02) Page 1 of 1
REPLACEMENT PARTS:
Lamp, Red (120V) 0820-001
Lamp, Red (120V), Shatterproof 0820-001-SP
Lamp, White (120V) 0820-033
Lamp, Red (240V), Shatterproof 0820-014-SP
Socket 0822-037
Switch 0808-002
Reel/Pulley Assembly 1287-084
Coil Cord (IFW63) 0834-006
Coil Cord (IFW63L) 0834-007
FL-2093
5. Lower or raise the coil cord to the height
you want.
6. Adjust the tension of the coil cord in the
slot as shown.
a. To increase tension, turn slot
clockwise.
b. To decrease tension, turn slot
counter clockwise.
7. Pull up canopy (2) and screw it to the
plate (4) with two machine screws (3).
8. Screw lamp into socket.
DO NOT PULL DOWN ON THE CORD
BEYOND THE STOP.
Loading...