Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
TROUBLE-SHOOTING CHART:
FAILUREPOSSIBLE CAUSE
1. Yellow light at switch
does NOT light.
2. Unit does not heat.
3. Unit gets too hot or
won’t shut off.
4. Blower does not work
or makes noise.
1a. Switch is “OFF”.
1b. Cord unplugged from wall outlet.
1c. Circuit breaker/fuse to wall outlet blown.
2a. Temperature Control set too low.
2b. Switch is “OFF”.
4a. Defective electrical parts. UNPLUG UNIT FROM WALL OUTLET.
5a. Defective blower.
Rev. 0 (2/07)Page 5 of 14
6a. The insulation inside the heating elements may have absorbed some
moisture. This may have occurred if the cabinet has not been used for a
long period of time or during shipping and storage of the cabinet. Drain
the water pan if needed. Plug the cabinet into a non-GFCI outlet and set
the Temperature Control to 200° (93°C). Let the cabinet run for about 1
5. GFCI device trips.
hour to dry out the heating elements from any moisture may have been
absorbed. If the circuit breaker trips, turn off cabinet, remove cord from
power source, and call the Factory Authorized Service Agent. After drying
the heating elements, plug cabinet into the GFCI receptacle; the cabinet
should run properly. If the GFCI trips, call the factory Authorized service
agent.
GFCI (ground-fault circuit interrupter): A GFCI receptacle is a device that de-energizes a circuit when it
detects an unsafe fl ow of current to ground. The intention of a GFCI device is to minimize the potential for an
electrical shock
If cause is none of the above, refer to our list of Authorized Service Agencies.
Page 8
Companion
Holding Cabinet
FL-2335-CLV
Rev. 0 (2/07)Page 6 of 14
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
ITEM DESCRIPTION120V208V240V
1Heater Kit, Air, 1000 Watts each0811-0740811-074-020811-074-01
2High Limit0848-0600848-0600848-060
3Power Cord0810-065-100810-039-020810-039-02
4Power Unit (See Page 8)0675-071-CLV0675-072-CLV0675-072-CLV
5Door - full, solid1221-557-K
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
Rev. 0 (2/07)Page 7 of 14
1
2
8
3
1
2
4
9
6
5
7
11
10
12
Page 10
Companion
Holding Cabinet
FL-2335-CLV
Rev. 0 (2/07)Page 8 of 14
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
REPLACEMENT PARTS FOR THE POWER UNIT:
18
17
16
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
19
20
13
14
15
REPLACEMENT PARTS:
ITEM DESCRIPTION120V208V240V
Power Unit0675-071-CLV0675-072-CLV0675-072-CLV
13 Power Light 0766-0940766-0950766-095
14 Power Switch0808-1160808-1160808-116
15 Temperature Control0848-075-K-CLV0848-075-K-CLV0848-075-K-CLV
16 Terminal Block0852-0930852-0930852-093
17 Relay0857-1300857-1020857-102
18 Blower Kit0769-180-01-SSK-CLV 0769-182-01-SSK-CLV 0769-182-01-SSK-CLV
19
Transformer (used with control)
0769-1590769-1590769-159
20 Vent Fan0769-1650769-1740769-174
Page 11
Companion
Holding Cabinet
FL-2335-CLV
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
Rev. 0 (2/07)Page 9 of 14
WIRING DIAGRAM
Page 12
Companion
Holding Cabinet
FL-2335-CLV
Rev. 0 (2/07)Page 10 of 14
OPERATING and MAINTENANCE INSTRUCTIONS
Models: HCDH-20.20 Companion Holding Cabinet
HOW TO REVERSE THE DOOR OPENING:
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
The doors on the HCDH2020 & HCWH2020 are shipped with the hinges on the left side of the cabinet
as standard. The doors on the cabinet are large and may require additional help when changing the hinge
direction. Allow the cabinet to cool if the cabinet has been in use.
Remove handle bracket and strike plates from cabinet and set aside.
1.
Remove hinge covers and set aside.
2.
Remove hex screws from door gasket bracket assembly and door cover and set aside.
3.
Remove door(s) from cabinet, rotate door(s) 180° and install onto other side of cabinet. For
4.
dutch doors, install the bottom door onto the top position and install the top door onto the bottom
position on the other side of the cabinet.
Remove screws on bottom of (lower) door and install onto top of (upper) door.
5.
Install door gasket assembly and door cover onto bottom of (lower) door.
6.
For single door, remove latch and rotate 180° and install onto holes on upper half of door. For
7.
dutch doors, it is not necessary to change latches.
Install handle bracket and strike plates onto other side of cabinet.
8.
Adjust hinges, latch(es) and door gasket bracket assembly for proper door seal.
9.
Install hinge covers.
10.
Page 13
Companion
100% FULL 5 YEAR BOILER
warranty on
NickelGuard
™
100% FULL 5 YEAR BOILER
warranty on
NickelGuard
™
Holding Cabinet
FL-2335-CLV
Cleveland Range, LLC
1333 East 179th Street
Cleveland, Ohio, 44110 U.S.A
Rev. 0 (2/07)Page 11 of 14
Cleveland STATEMENT OF POLICIES
LIMITED WARRANTY
CLEVELAND RANGE products are warranted to the original purchaser to be free from defects in material and work-manship under
normal use and service for the standard warranty period of one year from date of installation or 18 months from date of shipment, which
ever comes fi rst.
CLEVELAND RANGE agrees to repair or replace, at its option, f.o.b. factory, any part which proves to be defective due to defects
in material or workmanship during the warranty period, providing the equipment has been unaltered, and has been PROPERLY
INSTALLED, MAINTAINED, AND OPERATED IN ACCORDANCE WITH THE CLEVELAND RANGE OWNER’S MANUAL.
CLEVELAND RANGE agrees to pay any FACTORY AUTHORIZED EQUIPMENT SERVICE AGENCY (within the continental United
States, and Hawaii) for reasonable labor required to repair or replace, at our option, f.o.b. factory, any part which proves to be defective
due to defects in material or workmanship, during the labor warranty period. This warranty includes travel time not to exceed two
hours and mileage not to exceed 50 miles (100 miles round-trip), BUT DOES NOT INCLUDE POST START-UP, TIGHTENING LOOSE
FITTINGS, MINOR ADJUSTMENTS, MAINTENANCE, CLEANING OR DESCALING.
The standard labor warranty allows factory payment of reasonable labor required to repair or replace such defective parts. Cleveland
Range will not reimburse the expense of labor required for the repair or replacement of parts after the standard warranty period, unless
an Extended Labor Warranty Contract has been purchased to cover the equipment for the balance of the warranty period from the date
of equipment installation, start-up, or demonstration.
PROPER INSTALLATION IS THE RESPONSIBILITY OF THE DEALER, THE OWNER-USER, OR INSTALLING CONTRACTOR, AND
IS NOT COVERED BY THIS WARRANTY. Many local codes exist, and it is the responsibility of the owner and installer to comply with
these codes. Cleveland Range equipment is built to comply with applicable standards for manufacturers, including UL, A.G.A., NSF,
ASME/Ntl. Bd., CSA, CGA, ETL, and others.
BOILER (Steam Generator) MAINTENANCE IS THE RESPONSIBILITY OF THE OWNER-USER AND IS NOT COVERED BY THIS
WARRANTY. The use of good quality feed water is the responsibility of the Owner-User (see Water Quality Recommendations below).
THE USE OF POOR QUALITY FEED WATER WILL VOID EQUIPMENT WARRANTIES. Boiler maintenance supplies, including boiler
hand gaskets, are not warranted beyond the fi rst 90 days after the date the equipment is placed into service. Preventive maintenance
records must be available showing descaling per applicable Cleveland Operator Manual for Boiler Proration Program considerations.
WATER QUALITY RECOMMENDATIONS
TOTAL DISSOLVED SOLIDS less than 60 parts per million
TOTAL ALKALINITY less than 20 parts per million
SILICA less than 13 parts per million
CHLORIDE less than 30 parts per million
pH FACTOR greater than 7.5
The foregoing shall constitute the sole and exclusive remedy of original purchaser and the full liability of Cleveland Range for any
breach of warranty. THE FOREGOING IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, WHETHER WRITTEN,
ORAL, OR IMPLIED, INCLUDING ANY WARRANTY OF PERFORMANCE, MERCHANTABILITY, OR FITNESS FOR PURPOSE,
AND SUPERSEDES AND EXCLUDES ANY ORAL WARRANTIES OR REPRESENTATIONS, OR WRIT-TEN WARRANTIES OR
REPRESENTATIONS, NOT EXPRESSLY DESIGNATED IN WRITING AS A “WARRANTY” OR“ GUARANTEE” OF CLEVELAND
RANGE MADE OR IMPLIED IN ANY MANUAL, LITERATURE, ADVERTISING BROCHURE OR OTHER MATERIALS.
CLEVELAND RANGE’S liability on any claim of any kind, including negligence, with respect to the goods or services covered
hereunder, shall in no case exceed the price of the goods or services, or part thereof, which gives rise to the claim. IN NO EVENT
SHALL CLEVELAND RANGE BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OR ANY DAMAGES IN
THE NATURE OF PENALTIES.
LIMITED EXTENDED WARRANTY COVERAGE
The purchase of a Limited Extended Warranty Contract extends the standard warranty coverage to the purchased period of time (one to
two years) from the date of installation, start-up, or demonstration, whichever is sooner.
*An additional two years Parts and Labor Warranty can be purchased with each piece of Cleveland equipment for an
additional 2% of the List Price per year. The 2% of list price charge will be the net invoice amount for each year of extended
warranty purchased.
– Extended warranty must be purchased at the same time the equipment is purchased.
– Extended Warranty has the same exclusions as stated in our standard warranty.
Second year limited extended warranty coverage on Cleveland Steamers when purchased with a water fi lter applies to water related
components only.