Cres Cor H137S96BC Service Manual

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Model: H137S96BC Series Banquet Cabinet

ELECTRICAL SPECIFICATIONS:

Model No. Volts Watts Amps Hertz Phase NEMA

H137S96BC
USA only

H137S96BC CAN
USA / CAN

H137S96BC 208
USA / CAN

H137S96BC 240

USA / CAN

Note: The above model numbers are basic models. They may be followed by letters L, D, or ending

with an S.

125 1500 12.5 60 1 5-15P

125 1500 12.5 60 1 5-20P

208 2000 9.6 60 1 6-15P

240 2000 8.3 60 1 6-15P

Insulated

Banquet Cabinet

Rev. 4 (12/06) Page 1 of 4

FL-2258

HOW TO INSTALL UNIT:

Place cabinet on level fl oor.

1.
Plug cord end into proper wall outlet.

2.

HOW TO START UNIT:

Turn the POWER switch on. The yellow light will

1.
turn on.
Turn thermostat to #7.

2.
Preheat cabinet for 60 minutes.

3.
Put food into cabinet.

4.
Turn thermostat to #8 and close door.

5.
No. 8 setting = approx. 185°F (85°C)

No. 6 setting = approx. 160°F (71°C)
No. 4 setting = approx. 130°F (54°C)

TO TURN OFF UNIT:

Push the POWER switch off.
The yellow light will go out.

Proper food holding temperature is 140°F (60°C) or
higher.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com

Insulated

Banquet Cabinet

Rev. 4 (12/06) Page 2 of 4

FL-2258

OPERATING and MAINTENANCE INSTRUCTIONS

Model: H137S96BC Series Banquet Cabinet

HOW TO CLEAN THE CABINET:

BEFORE cleaning
the cabinet:

Allow cabinet to cool.

1.
Remove Hot unit from cabinet.

2.
Do NOT use abrasives or harsh

3.
chemicals.

HOW TO CLEAN THE UNIT:

SOIL CLEANER METHOD

Mild detergent* and hot water, or mild
abrasive cleaner.

Steam (no strong alkaline additive)

Chemical oven cleaner for aluminum.
Mild abrasive cleaner;

oily or waxy cleaner.

STAINLESS

STEEL

BANQUET

CABINET

DIRT

FINGERPRINTS,
GREASE OIL

WATER SPOTS Mild abrasive cleaner.

* Mild detergents include soaps and non-abrasive cleaners

5925 Heisley Road • Mentor, OH 44060-1833

Cleaning Notes:

Wipe up spills as soon as possible.

1.
Clean cabinet regularly to avoid heavy dirt build-up.

2.
Make a test spot with cleaner.

3.
Follow manufacturer’s directions on cleaner.

4.
Do not mix cleaners.

5.
Avoid drips and splashes.

6.

1. Use soft, damp cloth.

2. Rinse with hot water.

3. Wipe dry.

1. Rinse after steam cleaning.

2. Wipe dry.
Follow oven cleaner

manufacturer’s directions.
Apply with soft, clean cloth.

1. Wipe with damp cloth.

2. Rinse and dry.

TROUBLE-SHOOTING CHART:

FAILURE POSSIBLE CAUSE

1. Yellow light at switch does NOT light

2. Unit does not heat.

3. Unit gets too hot or won’t shut off. 3a. Defective electrical parts. UNPLUG UNIT

4. Blower does not work or make noise. 4a. Defective blower.

If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com

1a. Circuit breaker/fuse to wall outlet is blown.
1b. Cord is unplugged from wall outlet.
1c. Switch is “OFF”.

2a. Thermostat set too low or is “OFF”.
2b. Switch is “OFF”.

FROM WALL OUTLET.