Cres Cor H-135-SUA-5 User Manual
INSULATED
HOT CABINET
MODEL H-135-SUA-11
FEATURES AND BENEFITS:
• Fully insulated holding cabinet keeps prepared
foods at serving temperatures.
• Powerful, yet efcient, 1500 Watt heating system
maintains the right temperature to properly hold
products. Heats up to 200˚F (93˚C).
• Internal frame in body maintains structural rigidity.
• Body constructed of non-corrosive, stainless steel
for strength and ease of cleaning. Extended base
protects cabinet body.
JOB:
ITEM NO:
• Insulated Dutch doors prevent temperature loss;
door gaskets for proper seal. Field reversible for
exibility.
• Standard with right hand hinging; left hand hinging
available upon request.
• Recessed push/pull handles on both sides prevent
damage to walls; allows easy maneuvering.
• Safety-conscious anti-microbial latches reduce
the spread of germs.
• Eleven sets of wire universal angles accommodate
a large variety of pan sizes on adjustable 1-1/2"
centers.
• Slanted control panel has easy-to-read
thermometer; digital thermometer available upon
request. Entire assembly removable for cleaning
and maintenance.
• Heavy duty 5" swivel casters, two with brakes.
Provides mobility when fully loaded.
• Available in Half-size cabinet with ve sets of
Universal angles, Model H135ESUA-5
H-135-SUA-11
®
SANITATION
NSF/ANSI 4
ACCESSORIES and OPTIONS
(Available at extra cost):
q Full View Window Door
q Red Powder Coat Doors
q Extra Universal Angles
q Corner Bumpers
q Perimeter Bumper
q Push Handle
q 208 or 240 Volt Service
q Food Safe Digital Thermometer
See page B-20 for accessory details.
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: 440/350-7267
www.crescor.com
Page B-9.1
Dec., 2015
H-135-SUA-11
B
A
B
C
G
W
5-15P
CRES COR
MODEL NO.
H-135-SUA-11
H-135-SUA-5
CAP/ANGLES
PAN DIM "A" DIM "B" DIM "C" INSIDE DIMENSIONS
SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT
11
SETS
5
SETS
SEE NOTE
BELOW
SEE NOTE
BELOW
IN 25-3/4 33-1/2 69-3/4 21 27 54 LBS 225
MM 655 850 1775 533 690 1375 KG 102
IN 25-3/4 33-1/2 42 21 27 27-1/8 LBS
MM 655 850 1067 533 690 690 KG
NOTES: 1. Pan sizes 22" x 20" (560 x 510) Roast & Bake Pans, 10" x 20" (255 x 510) Roast & Bake Pans, 18" x 26" (460 x 660)
Bun Pans, 14" x 18" (355 x 460) Service Trays, 12" x 20" (305 x 510) Steam Table Pans.
Refer to Pan Size Chart at end of section.
2. When ordering bumpers, add 2" to overall dimensions.
CABINET:
• Body: 22 ga. stainless steel.
• Reinforcement: Internal framework of .100 aluminum.
• Insulation: Fiberglass, thermal conductivity (K factor) is .23 at
75˚F, 1" insulation in sidewalls and doors, 1-1/2" in top and back.
• Air tunnel: 22 ga. stainless steel; lift-out type, mounted on back panel.
• Push/pull handles (2): Black plastic; 5-1/2” vertical; recessed.
BASE:
• Full base construction, .125 aluminum.
• Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap.
250 lbs. each, temp. range -40˚/+180˚F. Delrin bearings. Front
casters equipped with brakes.
DUTCH DOORS:
• Field reversible.
• Formed 20 ga. stainless steel.
• Gaskets: Perimeter type, silicone rubber.
• Latches: Magnetic type with anti-microbial pull handle.
• Hinges (4): Chrome plated high-pressure cast zinc.
PAN SLIDES:
• Wire angles (.306 dia.) nickel chrome plated steel, mounted on
lift off posts.
• Spaced on 4-1/2" centers; adjustable on 1-1/2" centers.
HOT UNIT COMPONENTS:
• Removable bottom mount hot unit.
• Body: Formed .063 aluminum with black control panel.
• Thermostat: Electro-mechanical, room ambient to 200˚F. (93˚C.).
• Pilot light.
• Switch: ON-OFF rocker type.
• Power cord: Permanent, 6 ft., 14/3 ga. with molded right angle
plug.
• Heater: 1470 Watts.
• Blower motor.
• Thermometer.
POWER REQUIREMENTS:
• 1500 Watts, 120 Volts, 60 Hz., single phase, 12.6 Amps., 15
Amp. service.
SHORT FORM SPECIFICATIONS
Cres Cor Insulated Holding Cabinet Model
H-135-ESUA-___. Inner, outer and top liners of 22 ga.
stainless steel. (11 or 5) sets wire angles for multiple
pan sizes, adjust able spacing every 1-1/2". Field
reversible Dutch doors, 20 ga. stainless steel. Insulated
with 1-1/2” berglass in top and back, 1" in sidewalls
and doors. Removable 1500 Watt, 125 Volt power
unit. Full base, .125 aluminum. 5" swivel modulus
casters, Delrin bearings. Load capacity 250 lbs. each.
2-Year Parts / 1-Year Labor warranty. Provide the
following accessories: ____ _____ _____ CSA-US,
CSA-C, CSA to NSF4 listed.
WEIGHT
ACT.
In line with its policy to continually improve its products,
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: 440/350-7267
www.crescor.com
© Crescent Metal Products, Inc. 2015 All rights reserved. Litho in U.S.A.
CRES COR reserves the right to change materials and
specications without notice.
Loading...