Cres Cor CO-151-XW-UA-5DX User Manual

JOB:
ITEM NO:
AQUATEMP™/ROAST-N-HOLD
UNDERCOUNTER CONVECTION OVEN
FEATURES AND BENEFITS:
• Roast, cook, bake, reheat and hold with precise temperature and humidity control. Slow convected air system promotes natural browning for flavor and seals in natural juices.
• Moist heat, dry heat or a combination of both allows for a variety of food preparation and holding.
• Full 2000 Watts of power allows for reheating of prepared
meals or bulk items. Maximum temperature 350˚F. (176.5˚C.).
• 1850 Watt water heater with separate control and low water indicator.
• Energy Management Logic system electronically directs power to where it's needed most during different operating cycles.
• Pre-setting automatic controls for roasting and holding cycles allows for unattended operation 24 hours a day.
• Roast and hold over 100 lbs. (45.4 kg.) of meat in just 6 sq. ft. of floor space. Convenient undercounter height makes the most of valuable kitchen space.
• Non-venting oven, permitted by most local codes, provides easy, inexpensive installation.
• Stainless steel construction throughout for ease of cleaning.
• Smooth interior coved corners prevent food particle/grease buildup.
• Field reversible insulated door prevents temperature loss. Silicone door gasket for proper seal. High temperature ceramic magnetic latch for “easy open” and security during transport.
• Safety conscious anti-microbial latch protects against spreading germs. Standard with right hand hinging; left hand hinging available upon request.
• Non-corrosive stainless steel wire universal angles accommodate a large variety of pan sizes on adjustable 1-1/2" spacing. Supplied with five sets of angles and two raised wire grids.
• Heavy duty 2-1/2" swivel casters, two with brakes. (Provides mobility when fully loaded.)
Deluxe Models (-DX) have 18 factory or eld programmed cook
& hold cycles. Each programmed menu can be customized for
exact time and temperature needs. Probe cooking includes one
6" meat temperature probe and port.
®
SANITATION
NSF/ANSI 4
®
C US
Standard (-DE) Deluxe (-DX)
All Ovens come standard with
easy-to-read and operate
LED digital controls.
ACCESSORIES and OPTIONS (Available at extra cost):
q Deluxe version with 18 programmable menus
and 6" meat probe (or optional 3" food probe).
q Security Panel for Controls q Key Lock Latch q Extra Universal Angles q Extra Wire Grids q Side and Rear Bumpers q 4700 Watts, 208 Volt q 4700 Watts, 240 Volt q 3 Phase
See page E-10 for accessory details.
CO-151-XW-UA-5DE
Deluxe Controls are available with 18 programmable menus
and 6" meat probe.
5925 Heisley Road • Mentor, OH 44060-1833 Phone: 877/CRESCOR • Fax: 440/350-7267 www.crescor.com
Page E-4.1D
April, 2015
TM
POWER
( 0 )
OFF
TIMER
LOW
WATER
( I )
ON
HUMIDITY
PROOF
LOW
70
HOLD
250° F
COOK / RETHERM
170
150
330
350° F
DRY
1
2
100
130
160
190
220
270
190
210
230
250
310
290
4
3
8
MOIST
9
10
HIGH
7
MEDIUM
6
5
D
E
F
G
A
B
C
20
FLASHING - TIMIMG
MINUTESHOURS
START
STOP
TIME SELECT
40
190
200
210
0
C
F
100
60
80
20
120
140
220
180
105
95
100
90
70
60
160
80
5-1/8
4"
"A"
CO-151-XW-UA-5D
G
4-1/2
"B"
DETAIL OF PAN SLIDE
CRES COR
MODEL NO.
ANGLES
CO-151-XW-UA-5DE CO-151-XW-UA-5DX5SETS
Note: Refer to pan size chart at end of section.
CABINET:
• Body: 22 ga. stainless steel.
• Reinforcement: Internal framework of 16 ga. stainless steel.
• Insulation: Fiberglass, thermal conductivity (K factor) is .23 at
75˚F. 1-1/2" in back wall, door, base; 2" in side walls.
• Water pan: 4 Gallons; 16 ga. stainless steel with 1850 Watt heater and with petcock drain; mounted to base.
• Drip trough: Formed 18 ga. stainless steel; mounted to lower front of cabinet; removable drip pan.
• Air tunnel: 20 ga. stainless steel, lift-out type, mounted on rear wall.
BASE:
• One piece construction, .125 aluminum.
Casters: 2-1/2" dia., swivel, polyolen tires, 1-1/8 wide, load cap.
150 lbs. each, temp. range -40˚/+180˚F. Plain bearings. Front
casters equipped with brakes.
DOOR:
• Field reversible.
• Formed 22 ga. stainless steel.
• Latch: Anti-microbial chrome plated zinc with composite handle, ceramic magnetic type; mounted inboard.
• Hinges: Heavy duty chrome plated zinc, mounted inboard.
• Gasket: Perimeter type, silicone.
• Pan stop: Embossed.
PAN SLIDES:
• Stainless steel wire universal angles (.306 dia.) mounted on lift­out posts.
• (5) sets of angles adjustable on 1-1/2" centers.
• Grids (2): Nickel chrome plated steel, raised wire 17" x 25".
POWER REQUIREMENTS AVAILABLE:
• 2000 Watts, 120 Volts, 60 Hz., 1 phase, 16 Amps., 20 Amp. service.
PAN DIM "A" DIM "B" DIM "C" INSIDE DIMENSIONS
SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT
SEE NOTE
BELOW
IN 28-1/4 34 32 21-1/4 26-1/2 20 LBS 200
MM 718 864 815 540 675 510 KG 91
"C"
40"
6-30P
YXG
Z
L15-20P
W
G
5-20P
WEIGHT
ACT.
POWER UNIT COMPONENTS: (refer to above drawing)
Thermostat (roast/hold): Solid state digital control, 140°F to 350˚F (176.5˚C).
• Thermostat (humidity): Solid state digital control, room ambient to 95%.
• Switch: ON-OFF push button type.
• Thermometer: Digital.
• Power cord: Permanent, 6 ft.;
- Straight Blade Plug for 20 Amp.
• Air heaters (2): 925 Watts each.
• Water heater: 1850 Watts.
• Blower motors (4).
• Vent fans (3).
• Fuses (2): 6 amp.
INSTALLATION REQUIREMENTS:
• This model complies with section 59 of UL710B for emissions of grease laden air, and according to UL is not required to be placed under a ventilation hood. Check local requirements before installation.
SHORT FORM SPECIFICATIONS
Cres Cor AquaTemp Roast-N-Hold Convection Oven Model CO-151-XW-UA-5D_. 18 ga. stainless steel, recessed control panel with digital thermostats. Cabinet 22 ga. stainless steel. Stainless steel internal frame; coved corner interior. 16 ga. stainless steel water reservoir, 4 gallon capacity. Fiberglass insulation in sides 2”; back, door and base 1-1/2”. 22 ga. stainless steel door, high temperature anti-microbial magnetic latch, heavy duty hinges. (5) sets universal angles for multiple pan sizes and spacing. One piece base .125 aluminum. 2-1/2" swivel modulus casters, Delrin bearings. Load capacity 150 lbs. each. 2000 Watts, _____ Volts, 60 Hz., ____ Phase. 2-Year Parts / 1-Year Labor warranty. Provide the following accessories: ______ ______ ______. CSA-US, CSA-C, CSA to NSF4 listed.
In line with its policy to continually improve its products,
5925 Heisley Road • Mentor, OH 44060-1833 Phone: 877/CRESCOR • Fax: 440/350-7267 www.crescor.com
© Crescent Metal Products, Inc. 2015 All rights reserved. Litho in U.S.A.
CRES COR reserves the right to change materials and
specications without notice.
Loading...