JOB:
ITEM NO:
AQUATEMP™ ROAST-N-HOLD
GENTLE CONVECTION OVEN
MODEL CO-151-FW-UA-12D
FEATURES AND BENEFITS:
• Roast, cook, bake, reheat and hold with precise temperature
and humidity control. Slow convected air system promotes
natural browning for flavor and seals in natural juices.
• Moist heat, dry heat or a combination of both allows for a variety
of food preparation and holding.
• Full 8,000 Watts of power allows for rethermalization of
prepared meals or bulk items. Maximum temperature 350˚F.
(176.5˚C.).
• Standard 2000 Watt heater with automatic water fill system and
low water indicator. LED and water heater shut off when water
at critically low level.
• Standard solid state electronic control with large, clean, easyto-read and operate LED digital display to ensure holding at
precise food temperatures and moisture content.
• 18 factory or field programmed roast & hold cycles. Each
programmed menu can be customized for exact time,
temperature and humidity needs.
• AquaTemp system maintains optimum food texture through
continuous monitoring of both temperature and humidity.
Temperature and humidity values are measured, displayed and
controlled through intuitive solid state controller. Air temperature
is prioritized over humidity to ensure food safety.
• Standard with probe cooking, includes one 1-1/2" food
temperature probe.
• Roast and hold over 300 lbs. (136 kg.) of meat in just 7 sq. ft.
of floor space.
• Non-venting oven, permitted by most local codes, provides
easy, inexpensive installation.
• Stainless steel construction with smooth interior coved corners
for ease of cleaning and prevent food particle/grease buildup.
• Field reversible insulated Dutch doors prevent temperature loss.
Silicone door gaskets for proper seal. High temperature ceramic
magnetic latches for “easy open” and security during transport.
• Safety conscious anti-microbial latches protect against
spreading germs. Standard with right hand hinging; left hand
hinging available upon request.
• Non-corrosive stainless steel wire universal angles
accommodate a large variety of pan sizes on adjustable 1-1/2"
spacing. Supplied with 12 sets of angles and six raised wire
grids.
• Heavy duty 5" swivel casters, two with brakes. Provides mobility
when fully loaded.
POWER UNIT OPTIONS:
8000 Watts, 208 Volts, 1 Phase, 60 Hz.
8000 Watts, 240 Volts, 1 Phase, 60 Hz.
8000 Watts, 208 Volts, 3 Phase, 60 Hz.
8000 Watts, 240 Volts, 3 Phase, 60 Hz.
™
CO-151-FW-UA-12D
ACCESSORIES and OPTIONS
(Available at extra cost):
q 1-1/2" Food Temperature Probe
q Security Panel for Controls
q Tempered Glass Door Windows
q Key Lock Latches
q Extra Universal Angles
q Side and Rear Bumpers
q HAACP Documentation (built in USB port)
q Twist Lock Plug
See page E-10 for accessory details.
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: 440/350-7267
www.crescor.com
Page E-1.1
Sept., 2012
5-1/8
DETAIL OF
PAN SLIDE
4-1/2
9"
CO-151-FW-UA-12D
A
B
A
ON
OFF
C
B
G
6-50P
70"
X
Y G
Z
L15-30P
CRES COR
MODEL NO.
ANGLES
CO-151-FW-UA-12D
NOTES: 1. Pan sizes 22" x 20" (560 x 510) Roast & Bake Pans, 10" x 20" (255 x 510) Roast & Bake Pans, 18" x 26" (460 x 660)
Bun Pans, 14" x 18" (355 x 460) Service Trays, 12" x 20" (305 x 510) Steam Table Pans.
Refer to Pan Size Chart at end of section.
2. When ordering bumpers, add 2" to overall dimensions.
CABINET:
• Body: 22 ga. stainless steel.
• Reinforcement: Internal framework of 18 ga. stainless steel.
• Insulation: Fiberglass, thermal conductivity (K factor) is .23 at
75˚F. 1-1/2" in doors, top, base; 2" in sidewalls.
• Air tunnels: 22 ga. stainless steel; lift-out type, mounted on sides.
• Interior coved corners.
• Automatic water ll hook-up under rear of base.
BASE:
• One piece construction, .125 aluminum.
• Drip trough: Formed 18 ga. stainless steel mounted to front of
cabinet; removable drip pan.
• Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap.
250 lbs. each, temp. range -45˚/+180˚F. Delrin bearings. Front
casters equipped with brakes.
PAN DIM "A" DIM "B" DIM "C" INSIDE DIMENSIONS
CAP/
12
SETS
SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT
SEE NOTE
BELOW
IN 28-3/4 37-3/4 73-11/16 21-3/4 26-7/8 58 LBS 392
MM 730 960 1875 555 685 1475 KG 178
HOT UNIT COMPONENTS:
• Thermostat (retherm/hold): Solid state digital control, 140°F to
350˚F (176.5˚C).
• Thermostat (humidity): Solid state digital control, room ambient to 95%.
• Switch: ON-OFF push button type.
• Power cord: Permanent, 10 ft., 12/3 ga.
• Heaters: 1325 Watts each (6).
• Blower motors: (4).
• Vent fans: (3).
• Water pan: 4 gallons; 16 ga. 304 stainless steel with 1850 Watt
heater for humidity.
• Fuses: (2) 6 Amp.
• Probe: (1) 6", stainless steel.
INSTALLATION REQUIREMENTS:
• Check local vent hood codes for mobile Roast-N-Hold ovens.
DUTCH DOORS:
• Field reversible.
• Formed 22 ga. stainless steel.
• Latches: Chrome plated steel, high temperature ceramic
magnetic type.
• Hinges: Heavy duty chrome plated steel.
• Gaskets: Perimeter type, silicone.
• Pan stops: Embossed.
PAN SLIDES:
• Stainless steel wire universal angles (.306 dia.), mounted on
lift-out posts.
• 12 sets of angles; adjustable on 1-1/2" centers.
• Grids (6): Nickel chrome plated steel, raised wire 17" x 25".
POWER REQUIREMENTS AVAILABLE:
• 8,000 Watts, 208 Volts, 60 Hz., 1 phase, 39 Amps., 50 Amp. service.
• 8,000 Watts, 240 Volts, 60 Hz., 1 phase, 34 Amps., 50 Amp. service
• 8,000 Watts, 208 Volts, 60 Hz., 3 phase, 23 Amps., 30 Amp. service.
• 8,000 Watts, 240 Volts, 60 Hz., 3 phase, 20 Amps., 30 Amp. service
Cres Cor AquaTemp Roast-N-Hold Convection Oven
Model CO-151-FW-UA-12D. 20 ga. stainless steel,
recessed control panel. Cabinet 22 ga. stainless steel.
Stainless steel internal frame; coved corner interior. 16
ga. stainless steel 4 gallon water reservoir with automatic
water ll hook-up. Fiberglass insulation in sides 2”; back,
doors and base 1-1/2”. 22 ga. stainless steel door, high
temperature anti-microbial magnetic latches, heavy duty
hinges. (12) sets universal angles for multiple pan sizes
and spacing. One piece base .125 aluminum. 5" swivel
modulus casters, Delrin bearings. Load capacity 250 lbs.
each. 8,000 Watts, ______ Volts, 60 Hz., ___Phase.
2-Year Parts / 1-Year Labor warranty. Provide the
following accessories:____ _____ _____ .
SHORT FORM SPECIFICATIONS
WEIGHT
ACT.
In line with its policy to continually improve its products,
5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: 440/350-7267
www.crescor.com
© Crescent Metal Products, Inc. 2011 All rights reserved. Litho in U.S.A.
CRES COR reserves the right to change materials and
specications without notice.
Loading...