Cres Cor CO-151-FPW-UA-12D User Manual

JOB:

ITEM NO:

PASS-THRU AQUATEMP™ ROAST-N-HOLD

GENTLE CONVECTION OVEN

MODEL CO-151-FPW-UA-12D

FEATURES AND BENEFITS:

• Roast, cook, bake, reheat and hold with precise temperature
and humidity control. Supplied with 6" food probe to constantly
monitor and control internal food temperature throughout the
cooking and holding stages.

• Slow convected air system promotes natural browning for flavor
and seals in natural juices.

• Moist heat, dry heat or a combination of both allows for a variety
of food preparation and holding.

• Full 8,000 Watts of power allows for reheating of prepared
meals or bulk items. Maximum temperature 350˚F. (176.5˚C.).

• Standard 2000 Watt heater with automatic water fill system and
low water indicator. LED and water heater shut off when water
at critically low level.

• Standard solid state electronic control with large, clean, easy­to-read and operate LED digital display to ensure holding at
precise food temperatures and moisture content.

• 18 factory or field programmed retherm & hold cycles.
Each programmed menu can be customized for exact time,
temperature and humidity needs.

• AquaTemp system maintains optimum food texture through
continuous monitoring of both temperature and humidity.
Temperature and humidity values are measured, displayed and
controlled through intuitive solid state controller. Air temperature
is prioritized over humidity to ensure food safety.

• Non-venting oven, permitted by most local codes, provides
easy, inexpensive installation.

• Stainless steel construction and smooth interior coved corners
for ease of cleaning and prevent food particle/grease buildup.

• Field reversible insulated Dutch doors prevent temperature loss.
Silicone door gaskets for proper seal. High temperature ceramic
magnetic latches for “easy open” and security during transport.

• Safety conscious anti-microbial latches protect against
spreading germs. Standard with right hand hinging; left hand
hinging available upon request.

• Non-corrosive stainless steel wire universal angles
accommodate a large variety of pan sizes on adjustable 1-1/2"
spacing. Supplied with 12 sets of angles and six raised wire
grids.

• Heavy duty 5" swivel casters, two with brakes. Provides mobility
when fully loaded.

POWER UNIT OPTIONS:

8000 Watts, 208 Volts, 1 Phase, 60 Hz.
8000 Watts, 240 Volts, 1 Phase, 60 Hz.
8000 Watts, 208 Volts, 3 Phase, 60 Hz.
8000 Watts, 240 Volts, 3 Phase, 60 Hz.

™

CO-151-FPW-UA-12D

ACCESSORIES and OPTIONS
(Available at extra cost):

q 1-1/2" Food Temperature Probe

q Security Panel for Controls

q Tempered Glass Door Windows

q Key Lock Latches

q Extra Universal Angles

q Side Bumpers

q HAACP Documentation (built in USB port)

q Twist Lock Plug

See page E-10 for accessory details.

5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]

www.crescor.com

Page E-1.2

Sept., 2012

CO-151-FPW-UA-12D

5-1/8

4-1/2

DETAIL OF

3"

7"

C

A

B

PAN SLIDE

CRES COR

MODEL NO.

ANGLES

CO-151-FPW-UA-12D

NOTES: 1. Pan sizes 22" x 20" (560 x 510) Roast & Bake Pans, 10" x 20" (255 x 510) Roast & Bake Pans, 18" x 26" (460 x 660)

Bun Pans, 14" x 18" (355 x 460) Service Trays, 12" x 20" (305 x 510) Steam Table Pans.
Refer to Pan Size Chart at end of section.

2. When ordering bumpers, add 2" to overall dimensions.

CABINET:

• Body: 22 ga. stainless steel.

• Reinforcement: Internal framework of 18 ga. stainless steel.

• Insulation: Fiberglass, thermal conductivity (K factor) is .23 at
75˚F. 1-1/2" in doors, top, base; 2" in sidewalls.

• Air tunnels: 22 ga. stainless steel; mounted on sides.

• Interior coved corners.

• Automatic water ll hook-up under base.

BASE:

• One piece construction, .125 aluminum.

• Drip trough: Formed 18 ga. stainless steel mounted to front and
rear of cabinet; removable drip pans.

• Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap.
250 lbs. each, temp. range -45˚/+180˚F. Delrin bearings. Front
casters equipped with brakes.

DUTCH DOORS:

• Field reversible.

• Formed 22 ga. stainless steel.

• Latches: Chrome plated steel, high temperature ceramic
magnetic type.

• Hinges: Heavy duty chrome plated steel.

• Gaskets: Perimeter type, silicone.

• Pan stops: Embossed.

PAN SLIDES:

• Stainless steel wire universal angles (.306 dia.), mounted on
lift-out posts.

• 12 sets of angles; adjustable on 1-1/2" centers.

• Grids (6): Nickel chrome plated steel, raised wire 17" x 25".

POWER REQUIREMENTS AVAILABLE:

• 8,000 Watts, 208 Volts, 60 Hz., 1 phase, 39 Amps., 50 Amp. service.

• 8,000 Watts, 240 Volts, 60 Hz., 1 phase, 34 Amps., 50 Amp. service

• 8,000 Watts, 208 Volts, 60 Hz., 3 phase, 23 Amps., 30 Amp. service.

• 8,000 Watts, 240 Volts, 60 Hz., 3 phase, 20 Amps., 30 Amp. service

PAN DIM "A" DIM "B" DIM "C" INSIDE DIMENSIONS

CAP/

12

SETS

SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT

SEE NOTE

BELOW

IN 28-1/4 34-1/2 73-11/16 21-3/4 26-7/8 58 LBS 392

MM 720 880 1875 555 685 1475 KG 178

HOT UNIT COMPONENTS:

• Thermostat (retherm/hold): Solid state digital control, 140°F to
350˚F (176.5˚C).

• Thermostat (humidity): Solid state digital control, room ambient to 95%.

• Switch: ON-OFF push button type.

• Power cord: Permanent, 10 ft., 12/3 ga.

• Heaters: 1325 Watts each (6).

• Blower motors: (4).

• Vent fans: (3).

• Water pan: 4 gallons; 16 ga. 304 stainless steel with 1850 Watt
heater for humidity.

• Fuses: (2) 6 Amp.

• Probe: (1) 6", stainless steel.

INSTALLATION REQUIREMENTS:

• Check local vent hood codes for mobile Roast-N-Hold ovens.

SHORT FORM SPECIFICATIONS

Cres Cor Pass-Thru AquaTemp Roast-N-Hold Convection
Oven Model CO-151-FPW-UA-12D. 20 ga. stainless
steel, recessed control panel. Cabinet 22 ga. stainless
steel. Stainless steel internal frame; coved corner interior.
16 ga. stainless steel 4 gallon water reservoir with
automatic water ll hook-up. Fiberglass insulation in sides
2”; back, doors and base 1-1/2”. 22 ga. stainless steel
door, high temperature anti-microbial magnetic latches,
heavy duty hinges. (12) sets universal angles for multiple
pan sizes and spacing. One piece base .125 aluminum.
5" swivel modulus casters, Delrin bearings. Load capacity
250 lbs. each. 8,000 Watts, ______ Volts, 60 Hz., ___
Phase. 2-Year Parts / 1-Year Labor warranty. Provide the
following accessories:____ _____ _____ .

G

6-50P

X

Y G

Z

L15-30P

WEIGHT

ACT.

In line with its policy to continually improve its products,

5925 Heisley Road • Mentor, OH 44060-1833
Phone: 877/CRESCOR • Fax: [phone]

www.crescor.com

© Crescent Metal Products, Inc. 2012 All rights reserved. Litho in U.S.A.

CRES COR reserves the right to change materials and

specications without notice.