Cres Cor 1301836D208, 130 Installation Manual

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Model: 130 and 131 “D” Series Hot Cabinets

Model No. Volts Watts Amps Hertz Phase NEMA

1301836D
131UA11D
131UA9D

1301836D208
131UA11D208
131UA9D208

1301836D240
131UA11D240
131UA9D240

All are designed for AC service.

120 1920 16.6 60 1 5-20P

208 2000 9.6 60 1 6-15P

240 2000 8.6 60 1 6-15P

Proof/Hot Cabinets

Rev. 3 (6/05) Page 1 of 4

FL-2309

CONTROL PANEL PARTS IDENTIFICATION

1. Power Switch

2. Yellow Light-Power

3. Thermostat

4. Thermometer

HOW TO INSTALL UNIT:

Place cabinet near warm ovens. Do NOT put in

1.
drafty areas or near ventilating systems.
Plug cord end into proper wall outlet.

2.

HOW TO START UNIT:

Turn the POWER switch on. The yellow light will

1.
turn on.
Turn thermostat to #10.

2.
Preheat cabinet for 30 minutes.

3.
Put food into cabinet.

4.
Turn thermostat to #8 and close door.

5.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com

NOTE: No. 8 setting = approx. 175°F (79°C)

No.6 setting = approx. 165°F (74°C)

Proper food holing temperature is 140°F (60°C)
or higher. The thermometer shows the temperature
inside.

TO TURN OFF UNIT:

Turn thermostat off.

1.
Turn the POWER switch off.

2.
The yellow light will go out.

3.

Proof/Hot Cabinets

Rev. 3 (6/05) Page 2 of 4

FL-2309

OPERATING and MAINTENANCE INSTRUCTIONS

Model: 130 and 131 “D” Series Hot Cabinets

MAINTENANCE

HOT UNIT REMOVAL INSTRUCTIONS:

Unplug power cord from wall outlet.

1.
Remove screw from back of cabinet located just

2.
above cord. (For Model 1301836D ONLY).
Pull entire unit out the front of the cabinet.

3.

HOW TO CLEAN THE CABINET:

5925 Heisley Road • Mentor, OH 44060-1833

BEFORE cleaning
the cabinet:

Allow cabinet to cool.

1.
Remove Hot unit from cabinet.

2.
Do NOT use abrasives or harsh

3.
chemicals.

HOW TO CLEAN THE UNIT:

SOIL CLEANER METHOD

DOOR

and

CABINET

Inside and

Outside

(Aluminum)

DIRT

FINGERPRINTS,
GREASE OIL

WATER SPOTS Mild abrasive cleaner.

* Mild detergents include soaps and non-abrasive cleaners

Mild detergent* and hot water, or mild
abrasive cleaner.

Steam (no strong alkaline additive)

Chemical oven cleaner for aluminum.
Mild abrasive cleaner;

oily or waxy cleaner.

Cleaning Notes:

Wipe up spills as soon as possible.

1.
Clean cabinet regularly to avoid heavy dirt build-up.

2.
Make a test spot with cleaner.

3.
Follow manufacturer’s directions on cleaner.

4.
Do not mix cleaners.

5.
Avoid drips and splashes.

6.

1. Use soft, damp cloth.

2. Rinse with hot water.

3. Wipe dry.

1. Rinse after steam cleaning.

2. Wipe dry.
Follow oven cleaner

manufacturer’s directions.
Apply with soft, clean cloth.

1. Wipe with damp cloth.

2. Rinse and dry.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com