Cres Cor 120PH1836D, 121PHUA11D, 121PH1818D, 121PHUA11D208, 121PH1818D208 User Manual

Proof/Hot

Cabinets

FL-2306

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Model: 120PH and 121PH “D” Series Proof/Hot Cabinets

Model No. Volts Watts Amps Hertz Phase NEMA

120PH1836D

121PHUA11D

121PH1818D

120PH1836D208
121PHUA11D208
121PH1818D208

120PH1836D240
121PHUA11D240
121PH1818D240

All are designed for AC service.

HOW TO INSTALL UNIT:

1. Place cabinet near warm ovens. Do NOT put in
drafty areas or near ventilating systems.

120 1920 16.6 60 1 5-20P

208 2000 9.6 60 1 6-15P

240 2000 8.6 60 1 6-15P

Rev. 10 (11/13) Page 1 of 4

2. Plug cord end into proper wall outlet.

3. Fill water pan with 2 qts. (1.8 liters) of clean, hot
water.

HOW TO PROOF:

1. Fill water pan (See “How to Install”)

2. Push “POWER” switch to “ON.” The yellow light
will come on.

3. Push “MODE SELECTION” switch to “PROOF”.
The yellow light will come on.

4. Turn “HUMIDITY” dial to No. 8.

5. Turn “AIR” dial to “OFF”.

6. Preheat for 30 minutes.

7. Put fresh or fully thawed dough into cabinet.

NOTE: The cabinet temperature will drop temperature

inside cabinet if cold dough is added.

Do NOT put frozen dough into cabinet

CONTROL PANEL PARTS IDENTIFICATION

1. Switch - Power 5. Yellow Light - Proof

2. Yellow Light - Power 6. Red Light - Heat

3. Thermostat - Humidity 7. Switch - Mode Selection

4. Thermostat - Air 8. Thermometer

NOTE: No. 8 setting will give you an approximate

temperature of 95°F (35°C), and 90-95%
humidity. Experiment with different
“HUMIDITY” and “AIR” settings to get the
exact temperature and humidity you need. The
thermometer shows the temperature inside the
cabinet.

NOTE: Check water level in water pan if you are

proong longer than 90 minutes. Fill with

clean, hot water.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com

Proof/Hot

Cabinets

FL-2306

Rev. 10 (11/13) Page 2 of 4

OPERATING and MAINTENANCE INSTRUCTIONS

Model: 120PH and 121PH “D” Series Proof/Hot Cabinets

HOW TO HOLD

1. Push “POWER” switch to “ON.” The yellow light
will come on.

2. Push “MODE SELECTION” switch to “HEAT.”
The red light will come on.

3. Turn “AIR” dial to temperature needed.

NOTE: No. 8 is about 175°F (79°C).
No. 6 is about 165°F (74°C).

Proper food holding temperature
is 140°F (60°C) or higher.

4. Preheat cabinet for 30 minutes.

5. Put food into cabinet.

5925 Heisley Road • Mentor, OH 44060-1833

WARNING

RISK OF FIRE OR ELECTRIC SHOCK

DO NOT OPEN

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE

PERSONNEL ONLY

HOW TO TURN UNIT OFF:

Push “POWER” switch to “OFF” position.

HOT UNIT REMOVAL INSTRUCTIONS:

1. Unplug power cord from wall outlet.

2. Pull entire unit out the front of the cabinet.

BEFORE cleaning the

WARNING

1. Allow cabinet to cool.

cabinet:

DELIME OR DESCALE RESERVOIR

CAUTION

PARTS AS REQUIRED TO PREVENT

2. Remove Hot unit from cabinet.

3. Do NOT use abrasives or harsh chemicals.

DAMAGING BUILD-UP. WARRANTY
COVERAGE MAY BE AFFECTED
WITHOUT PROPER CLEANING.

HOW TO CLEAN THE CABINET:

• The door is a polycarbonate panel in a powder coated frame.

Use mild detergent and water, rinse and wipe dry with a soft cloth.

• The cabinet body (inside and outside) is aluminum.

THIS CABINET BODY IS INTENDED TO BE CLEANED USING HIGH PRESSURE CLEANING
METHODS.

Wipe up spills as soon as possible and clean cabinet regularly to avoid heavy dirt build-up.

Detergents will assist in removing dirt, grease and stains. Only use detergents recommended for pressure
washers.

• Empty water pan at least once a week.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com