Page 1
User and
Maintenance
SC250
www.crescentindustrial.co.uk
Guide
Page 2
ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual
SC250
www.crescentindustrial.co.uk
2. Fill the solution tank with clean
water. The clean water temperature
must not exceed 40 °C.
3. The tank cap can be used for
dosing the detergent. One full cap
is 30ml giving 0,5% detergent of
the 6L tank capacity. (*)
4. Adjust the handle to the desired
height.
Turn on the machine with the main
button.
1. Disconnect the battery charger
cable from the electrical main.
15. Clean the debris collection tray.15. Clean the squeegee and the cylin -
drical brush with water.
14. Remove the squeegee.
Unscrew by turning the knob
clockwise to remove the
cylindrical brush.
12. Wash with clean water the cover
and the vacuum grid.
11. Empty the recovery and solution
tank. Clean them with water.
11. For the transportation and the
parking of the machine, push
down the pedal (slightly lift the
front of the machine by tilting the
handlebar).
9. For double scrubbing, press the
button to switch off the vacuum.
10. Turn off the machine with the main
button.
5. Lift the pedal to lower the machine
and start working.
6. Grab the handles to activate the
7. Press the solution button, according
to the type of cleaning to be
performed.
8. For sweeping functions, lift/lock the
right lever to lift the front squeegee
in order to collect light debris.
At the end of the work
13. Check and clean the solution and
17. Charge the batteries: Connect the
battery charger cable from the
electrical main.
16. Clean the machine using a damp
cloth and where needed use a neutral cleaning product.
18. Then store the machine in a clean
and dry place.
ALWAYS FOLLOW THE DETERGENT DOSING RECOMMENDATION ON THE LABEL OF THE CHEMICAL PRODUCT USED.
Loading...