Creative Labs MF8170 Users Manual
Additional Safety and Regulatory information for
Sound Blaster Roar SR20
Regulatory Information
The following sections contain notices for various countries:
CAUTION: This product is intended for use with FCC/CE certified computer equipment. Please
check the equipment operating/installation manual and/or with the equipment manufacturer to
verify/confirm if your equipment is suitable prior to the installation or use of the product.
Federal Communication Commission (FCC) Interference Statement Notice for USA FCC Part 15:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC
Rules, this device must be installed with computer equipment certified to comply with Class B limits.
All cables used to connect to the computer and peripherals must be shielded and grounded.
Operation with non-certified computers or non-shielded cables may result in interference to
radio or television reception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the device.
Federal Communication Commission (FCC) Radiation Exposure Statement
Power is so low that no RF exposure calculation is needed.
Notice for Canada
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Cet appareil
numérique de classe B est conforme aux normes canadiennes NMB-003 et CNR-210.This
device complies with Industry Canada licence-exempt RSS standard. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received, includinginterference that may cause
undesirable operation. Cet appareil est conforme avec Industrie Canada RSS standard exempts
de licence.Son Fonctionnement est soumis aux deux conditions suivantes :
(1)Le matériel ne peut étre source D’interférences et
(2)Doit accepter toutes les interférences reques, Y compris celles pouvant provoquer un
fonctionnement indésirable.
CANADIAN CLASS B STATEMENT:
This digital device does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,”
ICES-003 of the Department of Communications. Cet appareil numerique respecte les limites
de bruits radioelectriques applicables aux appareils numeriques de Classe B prescrites dans la
norme sur le materiel brouilleur: “Appareils Numeriques,” NMB-003 edictee par le ministre des
Communications.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void
the user’s authority to operate the device. Toute modification non approuvée explicitement par le fournisseur
de licence de l’appareil peut entraîner l’annulation du droit de l’utilisateur à utiliser l’appareil.
DECLARATION OF CONFORMITY
According to the FCC96 208 and ET95-19
Manufacturer/Importer’s Name: Creative Labs, Inc.
Manufacturer/Importer’s Address: 1901 McCarthy Boulevard
Milpitas, CA. 95035
Tel: (408)428-6600
declares under its sole responsibility that the product
Trade Name: Creative
Model Numbers: MF8170
has been tested according to the FCC / CISPR22 requirement for Class B devices and
found compliant with the following standards:
EMI/EMC: ANSI C63.4, FCC Part 15 Subpart B& C
Complies with Canadian ICES-003 Class B & RSS-210 standards
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including Interference that may cause
undesirable operation.
Ce matériel est conforme à la section 15 des régles FCC.
Son Fonctionnement est soumis aux deux conditions suivantes :
(1) Le matériel ne peut étre source D’interférences et
(2) Doit accepter toutes les interférences reques, Y compris celles pouvant provoquer un
fonctionnement indésirable.
Supplementary Information:
Compliance Manager
Creative Labs, Inc.
March 3rd, 2014
Loading...