CRC 03180 User Manual
SAFETY DATA SHEET
www.crcindustries.com
1. Identification
Product identifier Quick Clean™ Safety Solvent and Degreaser
Other means of identification
Product code
Recommended use
Recommended restrictions
Manufacturer/Importer/Supplier/Distributor information
Manufactured or sold by:
Company name
Address
Telephone
General Information
Technical
Assistance
Customer Service
24-Hour Emergency
(CHEMTREC)
Website
03180
General purpose degreaser
None known.
CRC Industries, Inc.
885 Louis Dr.
Warminster, PA 18974 US
215-674-4300
800-521-3168
800-272-4620
800-424-9300 (US)
703-527-3887 (International)
2. Hazard(s) identification
Physical hazards
Health hazards
Environmental hazards
OSHA defined hazards
Label elements
Signal word
Hazard statement
Precautionary statement
Prevention
Response
Storage
Disposal
Compressed gasGases under pressure
Category 2Skin corrosion/irritation
Category 1BCarcinogenicity
Category 3 narcotic effectsSpecific target organ toxicity, single exposure
Category 2Hazardous to the aquatic environment,
long-term hazard
Not classified.
Danger
Contains gas under pressure; may explode if heated. Causes skin irritation. May cause
drowsiness or dizziness. May cause cancer. Toxic to aquatic life with long lasting effects.
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Do not puncture or incinerate container. Do not expose to heat or store at
temperatures above 49°C/120°F. Use with adequate ventilation. Open doors and windows or use
other means to ensure a fresh air supply during use and while product is drying. If you experience
any symptoms listed on this label, increase ventilation or leave the area. Avoid breathing mist or
vapor. Avoid breathing gas. Wash thoroughly after handling. Wear protective gloves/protective
clothing/eye protection/face protection. Avoid release to the environment.
If on skin: Wash with plenty of water. If skin irritation occurs: Get medical attention. Take off
contaminated clothing and wash before reuse. If inhaled: Remove person to fresh air and keep
comfortable for breathing. Call a poison center/doctor if you feel unwell. If exposed or concerned:
Get medical attention. Collect spillage.
Store locked up. Protect from sunlight. Store in a well-ventilated place. Exposure to high
temperature may cause can to burst.
Dispose of contents/container in accordance with local/regional/national regulations.
Material name: Quick Clean™ Safety Solvent and Degreaser
03180 Version #: 02 Revision date: 08-07-2014 Issue date: 09-18-2013
SDS US
1 / 9
Hazard(s) not otherwise
wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be
water pollutant under the Clean Water Act and should be prevented from contaminating soil or
classified (HNOC)
Supplemental information
When exposed to extreme heat or hot surfaces, vapors may decompose to harmful or fatal corrosive gases such as hydrogen
chloride and possibly phosgene.
None known.
3. Composition/information on ingredients
Mixtures
CAS number %Chemical name Common name and synonyms
Perchloroethylene 127-18-4Tetrachloroethylene
124-38-9Carbon dioxide
Specific chemical identity and/or percentage of composition has been withheld as a trade secret.
90 - 100
1 - 5
4. First-aid measures
Inhalation
Skin contact
Eye contact
Ingestion
Most important
symptoms/effects, acute and
delayed
Indication of immediate
medical attention and special
treatment needed
General information
Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON
CENTER or doctor/physician if you feel unwell.
Remove contaminated clothing. Rinse skin with water/shower. If skin irritation occurs: Get medical
advice/attention. Wash contaminated clothing before reuse.
Rinse with water. Get medical attention if irritation develops and persists.
In the unlikely event of swallowing contact a physician or poison control center. Rinse mouth.
May cause drowsiness and dizziness. Headache. Nausea, vomiting. Irritation of eyes and mucous
membranes. Irritation of nose and throat. Skin irritation. May cause redness and pain.
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
IF exposed or concerned: Get medical advice/attention. Ensure that medical personnel are aware
of the material(s) involved, and take precautions to protect themselves.
5. Fire-fighting measures
Suitable extinguishing media
Unsuitable extinguishing
media
Specific hazards arising from
the chemical
Special protective equipment
and precautions for firefighters
Fire-fighting
equipment/instructions
Dry chemical, CO2, or water spray.
Do not use water jet as an extinguisher, as this will spread the fire.
Contents under pressure. Exposure to high temperature may cause can to burst. When exposed to
extreme heat or hot surfaces, vapors may decompose to harmful or fatal corrosive gases such as
hydrogen chloride and possibly phosgene.
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
In case of fire: Stop leak if safe to do so. Move containers from fire area if you can do so without
risk. Containers should be cooled with water to prevent vapor pressure build up.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Methods and materials for
containment and cleaning up
Environmental precautions
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Wear appropriate protective equipment and clothing during clean-up. Avoid breathing
mist or vapor. Avoid breathing gas. Do not touch damaged containers or spilled material unless
advised if significant spillages cannot be contained. For personal protection, see section 8 of the
SDS.
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Keep
combustibles (wood, paper, oil, etc.) away from spilled material. This material is classified as a
from entering sewage and drainage systems which lead to waterways. Stop the flow of material, if
this is without risk. Collect spillage. Wipe up with absorbent material (e.g. cloth, fleece). Clean
surface thoroughly to remove residual contamination. For waste disposal, see section 13 of the
SDS.
Avoid release to the environment. Contact local authorities in case of spillage to drain/aquatic
environment. Prevent further leakage or spillage if safe to do so. Do not contaminate water. Avoid
discharge into drains, water courses or onto the ground.
Material name: Quick Clean™ Safety Solvent and Degreaser
03180 Version #: 02 Revision date: 08-07-2014 Issue date: 09-18-2013
SDS US
2 / 9
7. Handling and storage
well-ventilated place. Store away from incompatible materials (see Section 10 of the SDS).
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
US. OSHA Table Z-2 (29 CFR 1910.1000)
US. ACGIH Threshold Limit Values
US. NIOSH: Pocket Guide to Chemical Hazards
ACGIH Biological Exposure Indices
Precautions for safe handling
Conditions for safe storage,
including any incompatibilities
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Pressurized container: Do not pierce or burn, even after use. Do not use if spray
button is missing or defective. Do not spray on a naked flame or any other incandescent material.
Do not smoke while using or until sprayed surface is thoroughly dry. Use with adequate ventilation.
Open doors and windows or use other means to ensure a fresh air supply during use and while
product is drying. If you experience any symptoms listed on this label, increase ventilation or leave
the area. Do not cut, weld, solder, drill, grind, or expose containers to heat, flame, sparks, or other
sources of ignition. Use caution around energized equipment. The metal container will conduct
electricity if it contacts a live source. This may result in injury to the user from electrical shock
and/or flash fire. Avoid breathing mist or vapor. Avoid breathing gas. Avoid contact with eyes, skin,
and clothing. Avoid prolonged exposure. Use only in well-ventilated areas. Should be handled in
closed systems, if possible. Wear appropriate personal protective equipment. Observe good
industrial hygiene practices. Avoid release to the environment. Do not empty into drains. For
product usage instructions, please see the product label.
Level 1 Aerosol.
Contents under pressure. Do not puncture or incinerate container. Do not expose to heat or store
at temperatures above 49 °C/120 °F. Do not handle or store near an open flame, heat or other
sources of ignition. Exposure to high temperature may cause can to burst. Store in a
8. Exposure controls/personal protection
Occupational exposure limits
PEL 9000 mg/m3Carbon dioxide (CAS
124-38-9)
ValueComponents Type
5000 ppm
Ceiling 200 ppmTetrachloroethylene (CAS
127-18-4)
TWA 100 ppm
STEL 30000 ppmCarbon dioxide (CAS
124-38-9)
TWA 5000 ppm
STEL 100 ppmTetrachloroethylene (CAS
127-18-4)
TWA 25 ppm
STEL 54000 mg/m3Carbon dioxide (CAS
124-38-9)
TWA 9000 mg/m3
Biological limit values
ValueComponents Determinant Specimen Sampling Time
Tetrachloroethylene (CAS
0.5 mg/l Tetrachloroethy
127-18-4)
3 ppm Tetrachloroethy
* - For sampling details, please see the source document.
lene
lene
Blood
End-exhaled
air
ValueComponents Type
ValueComponents Type
ValueComponents Type
30000 ppm
5000 ppm
*
*
Material name: Quick Clean™ Safety Solvent and Degreaser
03180 Version #: 02 Revision date: 08-07-2014 Issue date: 09-18-2013
SDS US
3 / 9
Loading...