Page 1
BINDING
USER MANUAL
Page 2
PACKAGE CONTENTS OPTIONAL PACKAGE CONTENT
2.
1 x Binary footstrap Left – L
1 x Binary footstrap Right – R
1 x Hexa footpad Left – L
1 x Hexa footpad Right – R
1 x Binary bag
1 x Manual
4 x Binary Stix
4 x Screw M6 x 20
4 x Binary washer
Page 3
IF BOUGHT TOGETHER WITH A CRAZYFLY KITEBOARD
4 x Razor fin
8 x Razor fin screw 4.5 x 16
2 x Handle screw M6 x 10
1 x Handle
3.
Page 4
HOW TO MOUNT
1. Take 1 pc Binary Stix and 1 pc footpad right. Place the
Binary Stix through the footpad frame opening on the left
and on the right side.
4.
We suggest to use the middle position for the Binary Stix.
Page 5
2. Place the right footpad on the board and select
desired insert position. This determines your stance width.
5.
Page 6
6.
3. Put 2 pcs Binary washers in place, one to the left and
the other one to the right side of the footpad. Make sure
the holes in the washer are aligned with the inserts on the
board.
4. Tighten 2 pcs screws slightly - left and right side of the
footpad.
Page 7
5. Adjust the footpad angle to the desired position.
6. Fully tighten the screws. Please check the footpad
screws after the first few rides, as they may come loose. If
loose, make sure to fully tighten the screws.
7.
Page 8
8.
7. Take the Binary footstrap Right and open the velcro.
Thread the velcro through the Binary Stix on both left and
right side of the footstrap.
8. Slide the Binary Stix inside the footstrap.
Page 9
9. Step inside the Binary binding. Adjust the Binary
footstrap with the velcros for the best fit and close the
velcros.
10. The binding is ready to go.
9.
Page 10
10.
11. If further adjustments for the angle of the binding is
needed, loosen the screws a little until the Binary Binding
is able to spin. Adjust the angle again to the desired
position and fully tighten the screws.
Page 11
12. If further adjustments for the footstrap position and
footpad position are needed, undo the screws completely.
Lift up the Binary Binding, push the Binary Stix down so
they pop out of the footpad Frame. Adjust the Binary Stix
to the desired position and pop them back in the footpad
Frame. Mount the Binary Binding back on the board to the
desired position and fully tighten your screws.
13. Repeat the whole process on the left side. Enjoy the ride.
11.
Page 12
CRAZYFLYKITES.COM
REGISTER
YOUR GEAR
kiteboardingforchildren.com crazyflykites.com/register
© CrazyFly Kiteboarding 2018
Loading...