Crazy Fit Massage Energy Board Luxury series PP-9000 User Manual

PP-9000
Energy Board
Luxury series
USER'S MANUAL
IMPORTANT PRECAUTIONS
fore operating the ENERGY BOARD.
1.
nd precautions.
3. l surface,
feet of clearance behind it.
face
penings.
4
ust. Do not put
here
n
6 the age of 12 and pets
7.
ore than 300 pounds.
d.
10 e surge suppressor
11. Never leave the ENERGY BOARD unattended
g the power
ARD is not in use.
12. Do not attempt to raise, lower, or move the
13. I
r y of
t is made to
sce.
14
15.
WARNING: sk of burns
following important precautions and information be
It is the responsibility of the owner to ensure
that all users of this ENERGY BOARD are while it is running. Always remove unplu
adequately informed of all warnings cord when the ENERGY BO
a
2. Use the ENERGY BOARD only as described
in this manual.
Place the ENERGY BOARD on a leve
with at least eight
Do not place the ENERGY BOARD on any sur
that blocks air o
To protect the floor or carpet from damage,
place a mat under the ENERGY BOARD.
. Keep the ENERGY BOARD indoors,
away from moisture and d
the ENERGY BOARD in a garage or covered
patio, or near water.
5. Do not operate the ENERGY BOARD w
Aerosol products are used or where oxyge
is being administered.
. Keep children under
away from the ENERGY BOARD at all times.
The ENERGY BOARD should not be used
by persons weighing m
8. Never allow more than one person on the
ENERGY BOARD at a time.
9. When connecting the power cord ,
plug the power cord into a surge suppressor
(not included). Do not use an extension cor
. Keep the power cord and th
away from heated surfaces.
ENERGY BOARD until it is properly assembled.
nspect and tighten all parts of the ENERGY BOARD
egularly. Wrong usage could influence the stabilit
the ENERGY BOARD. For Example, the pos
upport you during an exercise to keep you in balan
One should NOT PUSH the post for stretching or use
the post to create more tension.
.Inspect and tighten all parts of the ENERGY BOARD
regularly.
Never insert or drop any object into any
opening.
16.DANGER: Always unplug the power
ing
GY BOARD, and before performing the
djustment procedures described
zed service
17. T e use
any
WARNI any exercise prog ly
cord immediately after use, before clean
the ENER
maintenance and a
in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
other than the procedures in this manual
should be performed by an authori
representative only.
his ENERGY BOARD is intended for in-hom
only. Do not use this ENERGY BOARD in
commercial,rental, or institutional setting.
NG: Before beginning this or ram, consult your physician. This is especial
important for persons over the age of 35 or persons with pre-exi tions sting health problems. Read all instruc
before using.
SAVE THESE INSTRUCTIONS
2
BEFORE YOU BEGIN
Handlebar
Display Panel
BodyFat sensor
Main support tube
Power cord
ENERGY BOAED plate
Motor case
Adju e foot pad stabl
n impressive arra
ore enjoyable
e call our Customer Service Department To
se note the product model
number and serial number before calling. The model
number of the ENERGY BOARD is PP-9000. The serial
ERGY
rself
EF SIDE
RIGHT SIDE
3
Thank you for selecting the revolutionary PP-9000
help us assist you, plea
ENERGY BOARD. The PP-9000 offers a
of features to make your home workouts m
y
and effective.
For your benefit, read this manual carefully before
using the ENERGY BOARD. If you have additional
questions,pleas
number can be found on a decal attached to the EN
BOARD Before reading further, please familiarize you
with the parts that are labeled in the drawing below.
T
`
`
L
EXPLODED DRAWING Model No. PP-9000
PART
NO.
Description Qty
PART
NO.
Description Qty
1 Lower part Frame 1 11
M8x40mm long socket button head bolt
2
2 Left Handlebar 1 12 M5 x 10mm Screw 4
3 Right Handlebar 1 13 M6 x 10mm Washer Screw 3
4 Left Handlebar support tube 1 14 M8 Spring Washer 4
5 Right Handlebar support tube 1 15 M5 Spring Washer 4
6 Panel case 1 16 M8 Washer 4
7 Main support tube 2 17 Lower Cable Connectors 1
8
M8x15mm long socket button head bolt
2 18 Body Fat sensor line A 1
9
M8x65mm long socket button head bolt
2 19 Body Fat sensor line B 1
10 M5 x 10mm Screw 4 20 Upper Cable Connectors 1
PP-9000 PARTS LIST
4
Loading...
+ 7 hidden pages