Crate & Barrel Twist Table Assembly Instruction
TWIST TABLE
HARDWARE
4 - screws 4 - small
bolts
TOOLS REQUIRED
4 - spring
washers
Missing hardware?
Please call
800.606.6387 for
replacements.
Thank you for purchasing the Twist Table. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and
prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
ASSEMBLY
base
allen wrench
(included)
(We recommend the use of hand tools instead of power tools)
phillips head screwdriver
(not included)
COMPONENTS
1 - center
connector
1 - tabletop
4 - legs
leg
wood dowel
tabletop
1 Place tabletop upside down onto a clean, padded
surface. Using an allen wrench, remove base from
tabletop as shown.
Made in Vietnam - r02 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
2 Fit pre-assembled wood dowels of 4 legs into
corresponding holes of base as shown.
base
TWIST TABLE
center
connector
NOTE: Do not fully
tighten bolts
3 With the assistance of another adult, position legs as
shown. Fit center connector into assembly and align
holes of center connector with holes of 4 legs as
shown. Loosely attach center connector to each leg
with 1 spring washer and 1 small bolt, using an allen
wrench.
NOTE: Do not over
tighten the screws
and bolts
4 Carefully position unit upright. Secure legs to base with
4 screws as shown, using a phillips head screwdriver.
Do not over tighten the screws. At this point, fully tighten
bolts with an allen wrench. Do not over tighten.
CLEANING & CARE
Clean surfaces with a dry or damp
soft cloth. Do not use abrasive
cleaners. Do not use furniture wax
or polish as the unit is finished with a
protective clear lacquer. It is recommended to use coasters to protect
surface from heat and water.
5 Attach base to tabletop with 4 flat washers, 4 spring washers and
4 large bolts as shown, using an allen wrench. Position unit upright.
Assembly is now complete.
Made in Vietnam - r02 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...