Crate & Barrel Spotlight 52 Desk Assembly Instruction

SPOTLIGHT DESK

HARDWARE

Thank you for purchasing the Spotlight Desk. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or
padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

COMPONENTS

8 - short
bolts

2 - screw
posts

Missing hardware? Please call 800.606.6387 for replacements.

4 - long
bolts

2 - barrel
nuts

12- split
washers

2 - set screws

12 - flat
washers

TOOLS REQUIRED

Phillips head screwdriver (included)

Flat head screwdriver

1 - tabletop
assembly

IMPORTANT:
Make sure to align
slot of screw post
parallel to leg

1 - crossbar

2 - leg frames
(1 left, 1 right)

Made in China r04 Page 1 of 2

Customer Service 800.967.6696 | www.crateandbarrel.com

1 Lay both leg frames face down on a padded surface as
shown. Insert 1 screw post into each leg and secure with a
flat head screwdriver. Important: Make sure to align slot on
top of screw post parallel to leg. Do not over tighten screw
posts.

SPOTLIGHT DESK

Align this hole with hole

A

on end of crossbar

Align this hole in
screw post
with hole in
top of crossbar

B

2 A) With the assistance of another adult, position legs as
shown. Insert 2 barrel nuts into the crossbar as shown.
Use a flat head screwdriver to align the hole on the side
of the barrel nut with the hole on the end of the crossbar.
B) Fit dowels of crossbar and screw posts of leg frames
into corresponding holes as shown. Make sure hole in
screw post aligns with hole in the top of the crossbar.

CORRECTLY ASSEMBLED

SIDE VIEW DETAIL

3 Secure crossbar to leg frames by inserting a set screw
into each barrel nut. Tighten with a phillips head screwdriver,
making sure set screw securely engages the screw post of
the leg frame.

NOTE:

Do not over tighten the bolts

A

B

Long Bolt

Short Bolts

4 A) Place tabletop assembly upside down on a padded surface. Fit
dowels of legs into corresponding holes in tabletop.
B. Fully extend drawer. Secure both leg frames from the inside with 8 short

bolts, 8 split washers and 8 flat washers. Insert 4 long bolts, 4 split
washers and 4 flat washers through the tabletop apron as shown. Fully

tighten, but do not over tighten all bolts with a phillips head screwdriver.
With the assistance of another adult, place desk assembly upright.
Assembly is now complete.

CLEANING AND CARE

Clean surfaces with a dry or damp soft
cloth. Do not use abrasive cleaners.
Do not use furniture wax or polish as
the wood is finished with a protective
clear lacquer.

Made in China r04 Page 2 of 2

Customer Service 800.967.6696 | www.crateandbarrel.com