Crate & Barrel Ripple Office Chair Assembly Instruction
RIPPLE OFFICE CHAIR
HARDWARE
Thank you for purchasing the Ripple Office Chair.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
COMPONENTS
10 - short
bolts
12 - spring
washers
Missing hardware? Please call 800.606.6387 for replacements.
2 - long
bolts
2 - rubber
washers
12 - flat
washers
TOOLS REQUIRED
allen wrench (included)
rubber
washers
1 - seat
1 - seat
adjuster
1 - base
Made in Taiwan - r01 Page 1 of 3
5 - casters
seat
1 - gaslift
2 - armrests
(1 left, 1 right)
1 Place seat upside down onto a clean, padded surface
as shown. Place 2 rubber washers onto seat as shown.
RIPPLE OFFICE CHAIR
short
bolt
spring
washer
flat
washer
FRONT
NOTE: Make
sure arrow on
adjuster points
towards front
edge of seat
2 Attach seat adjuster to seat as shown. Make sure
arrow on adjuster points toward the front edge of the
seat. Secure adjuster with 2 short bolts, 2 spring
washers, and 2 flat washers as shown, using an allen
wrench.
long
bolt
spring
washer
flat
washer
A
A
B
B
armrest
short
bolt
spring
washer
flat
washer
3 A) Secure seat adjuster with 2 long bolts, 2 spring
washers, and 2 flat washers as shown.
B) Attach armrests to seat as shown. Secure armrests
with 8 short bolts, 8 spring washers, and 8 flat washers.
B
gas
lift
base
A
caster
4 A) Firmly press fit the stems of 5 casters into holes on
the underside of the base.
B) Fit bottom of gas lift into hole of base as shown.
VIEW FROM
BELOW
5 Fit top of gas lift into corresponding hole on the
bottom of the seat assembly as shown.
NOTE: Finalize assembly by sitting heavily on the chair
a few times. This will secure all the component
connections.
Made in Taiwan - r01 Page 2 of 3
Loading...