QUBE 1-SECTION
HARDWARE
Thank you for purchasing the Qube 1-Section. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
8 - cams 8 - cam
screws
1 - bracket
1 - magnet
6 - small
screws
2 - medium
screws
2 - door
hinges
Missing hardware?
Please call 800.606.6387 for replacements.
TOOLS REQUIRED
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
NOTE: Do not over
tighten the cam screws
8 - large
screws
2 - side panels
(1 left, 1 right)
top
panel
1 - back panel
1 - top panel
1 - bottom panel
1 - door
bottom
panel
1 Insert 4 cam screws into top and bottom panels as
4 - feet
shown. Secure, but do not over tighten, cam screws using
a phillips head screwdriver.
Made in China - r03 Page 1 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
QUBE 1-SECTION
NOTE: Make sure arrows
on each cam point toward
nearest edge with holes
left and right
side panels
2 Insert 4 cams into 1 left and right side panels as
shown. Make sure arrows on each cam point toward
nearest edge with holes.
NOTE: Do not over
tighten the screws
magnet
top
panel
3 Attach 1 magnet to top panel with 2 medium screws
as shown, using a phillips head screwdriver. Do not over
tighten the screws.
right side
panel
foot
bottom
panel
4 Attach 4 feet to bottom panel with 2 large screws per
foot as shown, using a screwdriver.
5 Position bottom panel as shown. Fit cam screws of
bottom panel into corresponding holes of right side
bottom
panel
panel as shown. Using a phillips head screwdriver,
turn cams clockwise until each cam securely engages
each cam screw. Repeat for left side panel.
Made in China - r03 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
QUBE 1-SECTION
bracket
back
panel
6 Slide back panel into corresponding grooves of
assembled unit.
door
A
B
door hinge
door
7 A) Attach 2 door hinges to door with 2 small screws
per hinge as shown, using a screwdriver.
B) Attach 1 bracket to door with 2 small screws as
shown.
top panel
peg
8 Fit pegs of door hinge into corresponding hole of
bottom panel.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not
use furniture wax or polish as the wood is finished with a protective clear lacquer.
NOTE: Make sure
magnet faces out
as shown
9 Fit cam screws of top panel into corresponding
holes of assembled unit as shown. Secure all cams.
Assembly is now complete.
Made in China - r03
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Page 3 of 3
Loading...