
LOOP FLOOR MIRROR
HARDWARE
Thank you for purchasing the Loop Floor Mirror. This
page
lists all the contents included in the box. Please
take the time to identify the hardware as well as the
individual components
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
to this product. As you unpack
COMPONENTS
12 - cams
12 - cam
covers
1 - short
wood screw
Missing hardware? Please call 800.606.6387 for replacements.
12 - cam
screws
9 - wood
dowels
1 - wall
anchor strap
1 - plastic
wall anchors
1 - long
wood screw
TOOLS REQUIRED
Phillips head screwdriver
2 - side panels
(1 left, 1 right)
1 - mirror frame
1 - base panel
B
Arrow on
each cam
points towards
nearest edge
with holes
A
C
1 A) Insert 4 wood dowels into each side panel as shown.
B) Insert 4 cams into each side panel as shown. Make sure
arrow on each cam points towards nearest edge with holes.
C) Insert 4 cams and 1 wood dowel into the base panel.
Made in China r06
Customer Service 800.967.6696 | www.crateandbarrel.com
Page 1 of 3

LOOP FLOOR MIRROR
NOTE:
Do not over tighten the cam screws
A
B
2 A) Insert 2 cam screws into each side panel as shown.
Secure, but do not over tighten with a phillips head
screwdriver.
B) Attach 8 cam screws to the mirror frame as shown.
SIDE VIEW
side panels
cams
base panel*
*NOTE: Make sure tapered edge of the
base panel fits against the mirror frame.
3 Fit side panels onto base panel as shown, aligning dowels
and cam screws with corresponding holes in base panel.
Secure all 4 cams by turning clockwise with a phillips head
screwdriver until each cam securely engages each cam screw.
4 With the assistance of another adult, place mirror frame
face down on a clean, padded surface. Position side panel
assembly as shown, and fit onto cam screws of mirror frame.
Secure all 8 cams with a phillips head screwdriver.
Made in China r06
Customer Service 800.967.6696 | www.crateandbarrel.com
5 With assistance, place the mirror upright. Conceal all
exposed cams with plastic cam covers. Assembly is now
complete.
Page 2 of 3

LOOP FLOOR MIRROR
NOTE:
This floor mirror is intended for
placement against a wall using
the enclosed anchoring hardware.
The included hardware is for
mounting the unit to drywall.
Use hardware appropriate to
your wall type.
6 A. Drill a hole in the wall slightly
smaller than the diameter of the
plastic wall anchor. Lightly tap with a
hammer until the face is flush with the
wall.
B. Insert long wood screw through
wall anchor strap and into the wall
anchor.
C. Insert short wood screw through
wall anchor strap and into the top of
unit.
Short
wood
screw
NOTE: Insert screws 3/4"-1"
from the edge of the strap
Wall
anchor
strap
Long
wood
screw
Wall
Plastic
wall
anchor
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Made in China r06
Customer Service 800.967.6696 | www.crateandbarrel.com
Page 3 of 3