Crate & Barrel Loop File Assembly Instruction
LOOP FILE
HARDWARE
Missing hardware? Please call
800.606.6387 for replacements.
Thank you for purchasing the Loop File. This page lists
all the contents included in the box. Please take time
to identify the hardware as well as the individual components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or
padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
4 - pull
screws
1 - small
screw
2 - file rails
TOOLS REQUIRED
phillips head screwdriver
COMPONENTS
1 - file
cabinet
1 - large
screw
1 - plastic
anchor
1 - wall
strap
2 - pulls
file
cabinet
pull
1 Pull out each drawer from file cabinet. Attach 1 pull to
each drawer with 2 screws as shown. Secure screws with
a phillips head screwdriver.
foam
drawer
assembly
foam
2 Please remove packing foam located between each
drawer assembly and file cabinet as shown. If packing
foam is difficult to remove, detach drawer assembly from
drawer glides. For instructions on removing/attaching
drawer assembly, refer to diagram on page 2.
file
cabinet
Made in China - r08 Page 1 of 2
Customer Service 800.967.6696 | www.crateandbarrel.com
LOOP FILE
A
Insert file rails into
outer notches
Insert file rails into
inner notches
A
Legal
Hanging
Files
B
Letter
Hanging
Files
3 A) For legal hanging files, insert file rails into outer
notches as shown, and fit file hooks over file rails.
B) For letter hanging files, insert file rails into inner notches
as shown, and fit hooks over file hooks over file rails.
Assembly is now complete.
SAFETY MOUTNING
INSTRUCTIONS
left drawer
glide
B
A
B
A) Remove drawer assembly from file pedestal:
Fully extend drawer assembly from file cabinet. Locate plastic tabs
on left and right drawer glides. With even pressure, simutaneously
lift the left tab (A) and press the right tab (B) to release drawer
assembly from assembled unit.
B) Attach drawer assembly to file pedestal:
Fully extend drawer glides from file cabinet. Fit drawer glides of
drawer assembly into corresponding drawer glides of file cabinet.
Push drawer assembly forward and listen for a click to ensure that
assembly is secure.
NOTE: Insert screws 3/4"-1"
from the edge of the strap
right drawer
glide
A. Drill a hole in the wall slightly
smaller than the diameter of the
plastic anchor. Lightly tap with a
hammer until the face is flush with
small
screw
wall
strap
WALL
the wall.
B. Insert large screw through
wall strap and into the wall
anchor.
plastic
anchor
C. Insert small screw through
wall anchor strap and into the top
of unit.
Mounting assembly is now
complete.
large
screw
NOTE:
If you are unsure about your
wall type or what mounting
method you should use, consult
a qualified professional or your
local hardware store.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.
Made in China - r08 Page 2 of 2
Customer Service 800.967.6696 | www.crateandbarrel.com
Loading...