Crate & Barrel Loop Bench Assembly Instruction

LOOP STORAGE BENCH

HARDWARE

Thank you for purchasing the Loop Storage Bench.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
NOTE: 2 people are required to safely assemble this
product.

COMPONENTS

14 - cams

12 - wood
dowels

4 - bumpers

Missing hardware? Please call 800.606.6387 for replacements.

14 - cam
screws

14 - cam
covers

18- large
screws

3 - hinges

8 - small
screws

2 - lid
supports
(1 left,
1 right)

TOOLS REQUIRED

Phillips Head Screwdriver

1 - top panel

1 - back panel

2 - side frames
(1 left, 1 right)

Made in China r07 Page 1 of 3

Customer Service 800.967.6696 | www.crateandbarrel.com

1 - front panel

1 - bottom panel

LOOP STORAGE BENCH

Arrow on each

cam points towards

nearest edge

with holes

A

Back Panel

Front Panel

B

1 A) Place back panel face up on a padded surface as
shown. Insert 2 wood dowels, 3 cam screws, and 4
cams into the holes as shown. Secure each cam screw,
but do not over tighten with a phillips head screwdriver.
Make sure the arrow on each cam points towards the
nearest edge with holes.
B) Insert 2 wood dowels, 3 cam screws, and 4 cams into
the front panel.

2 Insert 4 wood dowels and 4 cam screws into each side
panel as shown.

3 Insert 6 cams into the bottom panel as shown. Make
sure the arrow on each cam points towards the nearest edge
with holes.

Cam in
unlocked
position

4 Fit cam screws & dowels of front and back panel into
corresponding holes in the bottom panel. Secure 6 cams on
the bottom panel with a phillips head screwdriver. Turn

Cam in
locked
position

each cam clockwise until it securely engages each cam
screw.

Made in China r08 Page 2 of 3

Customer Service 800.967.6696 | www.crateandbarrel.com