Crate & Barrel Loop 64 Media Center Assembly Instruction
LOOP 64” MEDIA STAND
HARDWARE
Thank you for purchasing the Loop 64” Media Stand.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
12 - cams 12 - cam
screws
Missing hardware? Please call 800.606.6387 for replacements.
12 - wood
dowels
TOOLS REQUIRED
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
ASSEMBLY
1 - media stand
assembly
leg A
NOTE: Do not over
tighten the cam
4 - legs
(2 leg A, 2 leg B)
1 - support leg
Made in China - r01 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
2 - crossbars
screws
leg B
1
Insert 3 cam screws and 3 wood dowels into each leg
as shown. Secure, but do not over tighten, the cam
screws with a phillips head screwdriver.
LOOP 64” MEDIA STAND
A
leg A
NOTE: Make sure arrows
on each cam points toward
nearest edge with holes
B
crossbar
2 A) With the assistance of another adult, place the
media stand assembly upside down onto a clean,
padded surface. Insert 4 cams into each side panel of
the media stand assembly as shown. Make sure
arrows on each cam points toward nearest edge with
holes
B) Insert 2 cams into each crossbar as shown.
C
B
leg B
3 Fit cam screws of leg A and leg B into corresponding
holes of media stand assembly. With a phillips head
screwdriver, turn each cam clockwise until it securely
engages each cam screw.
CLEANING & CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the unit is finished with a protective clear lacquer.
A
leg B
leg A
4 A) Fit crossbars onto cam screws of remaining leg A
and B as shown. Secure cams with a screwdriver.
B) Fit remaining leg A and B into corresponding holes in
the crossbars and media stand assembly as shown.
Secure all cams.
C) Attach support leg to media stand assembly by
turning support leg clockwise. With the assistance of
another adult, turn media stand assembly upright.
Assembly is now complete.
Made in China - r02 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...