Crate & Barrel Kingston Sliding Door Coffee Table Assembly Instruction

KINGSTON SLIDING DOOR COFFEE TABLE

HARDWARE

Thank you for purchasing the Kingston Sliding Door
Coffee Table. This page lists all the contents included

in the box. Please take time to identify the hardware as
well as the individual components of this product. As
you unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect them
from damage.

Note: 2 people are required to safely assemble this product.

COMPONENTS

12 - bolts

6 - cams

Missing hardware? Please call 800.606.6387
for replacements.

12 - spring
washers

6 - cam
screws

TOOLS REQUIRED

Phillips head screwdriver

12 - flat
washers

1 - top panel

2 - side panels
(1 left, 1 right)

1 - back panel

1 - bottom panel

2 - doors
(1 left, 1 right)

Made in China - r04 Page 1 of 2

Customer Service 800.967.6696 | www.crateandbarrel.com

KINGSTON SLIDING DOOR COFFEE TABLE

B

A

Make sure arrow on each
cam points towards nearest
edge with holes.

1 Insert 2 cam screws into back panel as shown.
Secure, but do not over tighten with a phillips head
screwdriver. Insert 2 cams into bottom panel as shown.
Make sure arrow on each cam points towards nearest
edge with holes. Fit cam screws and dowels of back
panel into corresponding holes of bottom panel. With a
screwdriver, turn each cam clockwise until it securely
engages each cam screw.

B

2 A) Insert 4 cams into bottom panel as shown. Insert 2 cam
screws into each left and right side panel as shown.

B) Fit left and right side panel onto back and bottom panel
assembly by fitting cam screws and dowels into corresponding
holes as shown. With a screwdriver, turn each cam clockwise until
it securely engages each cam screw. Secure side panels with 4
bolts, 4 spring washers, and 4 flat washers as shown, using a
screwdriver.

A

right
side door

left
side door

4 With the assistance of another adult, carefully place unit
upright. Insert bottom edge of right door into bottom back
groove of unit as shown. Press and hold down both levers
(located at the back of door) to insert top edge of door into
top back groove of unit. Release levers to secure door.
Repeat for left door using the front groove of unit.

Assembly is now complete.
3 With the assistance of another adult, carefully
attach top panel onto assembled unit as shown with 8
bolts, 8 spring washers and 8 flat washers.

Made in China - r04 Page 2 of 2

Customer Service 800.967.6696 | www.crateandbarrel.com

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.