Crate & Barrel Kingston Low Cabinet Assembly Instruction
KINGSTON LOW CABINET
HARDWARE
Thank you for purchasing the Kingston Low Cabinet.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
6 - cams 6- cam
screws
4 - pull
screws
Missing hardware? Please call 800.606.6387 for replacements.
18 - bolts 18- spring
washers
19 - screws2- pulls
1- shelf
pin
18- flat
washers
TOOLS REQUIRED
Phillips head screwdriver
1 - front frame
1 - bottom panel 1 - fixed shelf
Made in China R04 Page 1 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
1 - back panel
1 - left panel
1 - top panel
1 - center support1 - right panel
KINGSTON LOW CABINET
Make sure arrows
on each cam point
towards nearest holes
on edge of panel.
A
B
1 A) Insert 2 cam screws into left side panel as
shown. Secure with a Phillips head screwdriver,
but do not over tighten cam screws. Repeat step for
right side panel.
B) Insert 4 cams in holes located on bottom panel.
Make sure arrows on each cam point towards nearest
edge with holes.
2 Attach left and right side panels onto bottom
panel and shelf panel by aligning cam screws on
bottom panel and dowels on shelf panel with
corresponding holes. Secure shelf panel with 4
bolts, 4 spring washers, and 4 flat washers using a
Phillips head screwdriver.
B
A
C
B
C
3 A) Secure cams using a Phillips head
screwdriver. Turn each cam clockwise until it
securely engages each cam screw.
B) Attach center support to bottom panel on
assembled unit as shown with 2 bolts, 2 spring
washers, and 2 flat washers. Secure with a Phillips
head screwdriver.
C) Insert 2 cams into remaining holes located on
bottom panel. Make sure arrows on each cam point
towards nearest edge with holes.
A
B
B
C
4 A) Insert 2 cam screws into front frame as shown.
Secure with a Phillips head screwdriver.
B) With assistance of another adult, carefully fit front
frame onto assembled unit by aligning cam screws with
corresponding holes. Secure with 4 bolts, 4 spring
washers, and 4 flat washers using a Phillips head
screwdriver.
C) Secure cams using a Phillips head screwdriver.
Turn each cam clockwise until it securely engages each
cam screw.
Made in China R04 Page 2 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
Loading...