Crate & Barrel Kingston 52 Media Console Assembly Instruction

KINGSTON 52” MEDIA STAND

HARDWARE

Thank you for purchasing the Kingston 52” Media
Stand. This page lists all the contents included in the

box. Please take time to identify the hardware as well as
the individual components of this product. As you
unpack and prepare for assembly, place the contents on
a carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

COMPONENTS

4 - cams 4- cam

screws

8 - flat
washers

Missing hardware? Please call 800.606.6387 for replacements.

8 - spring
washers

8 - bolts 2 - large

screws

20 - screws

16- shelf
pins

TOOLS REQUIRED

Phillips head screwdriver

1 - top panel

1 - bottom panel

Made in Vietnam - r07 Page 1 of 3

Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com

1 - back panel

1 - middle
partition

4 - adjustable
shelves

1 - left side
panel

1 - left sliding
door panel

1 - right side
panel

1 - center
support

1 - right sliding
door panel

KINGSTON 52” MEDIA STAND

A

B

Make sure arrows
on each cam point
towards nearest edge
with holes.

1 A) Insert 2 cam screws into left side panel as
shown. Secure with a Phillips head screwdriver,
but do not over tighten cam screws. Repeat step for

right side panel.

B) Insert 4 cams into holes located on bottom panel.
Make sure arrows on each cam point towards nearest
edge with holes.

B

B

A

NOTE: Do not over
tighten the screws.

2 A) Attach middle partition and bottom panel by
aligning holes with pre-assembled dowels. Secure

middle partition with 2 large screws using a Phillips
head screwdriver. Do not over tighten the screws.

B) Attach center support onto bottom panel by
aligning holes with pre-assemble dowels. Secure
center support with 2 bolts, 2 spring washers, and
2 flat washers using a Phillips head screwdriver.

B

A

3 A) Carefully fit left and right side panels onto
assembled unit by aligning cam screws and dowels
with corresponding holes.
B) Secure cams using a Phillips head screwdriver.
Turn clockwise until each cam securely engages each
cam screw.

Made in Vietnam - r07 Page 2 of 3

Customer Service 800.967.6696 | Latest instructions available on www.crateandbarrel.com

4 Attach top panel onto assembled unit by aligning
holes with pre-assembled dowels. Secure left side

panel, right side panel, and middle partition with 6
bolts, 6 spring washers, and 6 flat washers using a
Phillips head screwdriver.