Crate & Barrel Horizon Two-Door Cabinet Assembly Instruction
HORIZON 2 DOOR CABINET
ASSEMBLY HARDWARE
8 - bolts
8 - flat
washers
MOUNTING HARDWARE
8 - spring
washers
Missing hardware?
Please call
800.606.6387 for
replacements.
Thank you for purchasing the Horizon 2 Door Cabinet.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
4 - legs
NOTE: Do not over
tighten the bolts
2 - wall
straps
4 - wall
brackets
4 - large
screws
4 - small
screws
TOOLS REQUIRED
allen wrench (included)
phillips head screwdriver
(We recommend the use of hand tools instead power tools)
cabinet
assembly
4 - plastic
anchors
leg
With the assistance of another adult, carefully place cabinet assembly
onto a clean, padded surface as shown. Attach 4 legs to cabinet
assembly with 2 bolts, 2 spring washers and 2 flat washers per leg.
1 - cabinet
assembly
Made in Vietnam - 05 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Secure, but do not over tighten the bolts, using an allen wrench.
Carefully position unit upright.
Assembly is now complete.
HORIZON 2 DOOR CABINET
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as
the wood is finished with a protective clear lacquer.
SAFETY MOUNTING INSTRUCTIONS:
For added safety and stability, it is recommended that
the wall mounting hardware be installed. For safe
mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall,
concrete, etc.). Mount to wood studs whenever
possible.
A) Attach 2 wall brackets to back of unit using 4
small screws as shown.
B) Determine the final location of unit. Mark position
on the wall, approximately 2" below each wall bracket
mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller
in diameter than the anchor. Gently tap the plastic
anchor until the flange of the anchor is flush with the
wall.
D) Attach wall brackets to the wall by inserting 2
large screws through each bracket and each plastic
anchor in the wall.
E) Place the unit so the wall brackets on the back
edge are aligned with the wall brackets on the wall.
F) Lace one end of the wall straps through each
bracket, and into the other end of the strap.
G) Pull the strap tightly until secure.
Wall mounting assembly is now complete.
WALL
C
plastic
anchor
D
large
screw
wall
bracket
A
small
screw
F
wall
strap
wall
bracket
NOTE:
If you are unsure about your wall type or what
mounting method you should use, consult a
qualified professional or your local hardware
store.
Made in Vietnam - r05 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...