Crate & Barrel Flex Bookcase Assembly Instruction
Customer Service 800-967-6696 | http://www.crateandbarrel.com
FLEX BOOKCASE
Thank you for purchasing the Flex Bookcase. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or padded
area to protect them from damage.
Note: 2 people are required to safely assemble this
product.
COMPONENTS
2 - main frames
12 - crossbars
5 - glass shelves
Made in Taiwan- r02
HARDWARE
24 - bolts 4 - levelers 2 - screws
2 - drywall
anchors
Missing hardware? Please call 800.606.6387 for replacements.
20 - rubber
bumpers
2 - wall straps
TOOLS REQUIRED
Allen Wrench (included)
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners.
x 12
1 Place 1 main frame on a padded surface with the
brackets facing up as shown. Fit open tube ends of each
crossbar onto each tab. Loosely attach each crossbar
with 1 bolt. Do not fully tighten bolts.
Page 1 of 2
Customer Service 800-967-6696 | http://www.crateandbarrel.com
FLEX BOOKCASE
2 Fit brackets of remaining main frame into ends of
crossbars. Secure each crossbar with 1 bolt, fully
tightening with the allen wrench. At this point, fully
tighten 12 bolts installed in Step 1 with the allen wrench.
4 With the assistance of another adult, turn assembly
upright. Carefully place 5 glass shelves into position,
making sure each is firmly supported by the rubber
bumpers. Assembly is now complete.
Made in Taiwan - r02
x 24
A
B
3 A. Insert 4 levelers into the bottom of the legs as
shown. Turn each leveler clockwise to secure.
B. Adhere 2 rubber bumpers to each crossbar as shown.
OPTIONAL WALL ATTACHMENT
These instructions are for drywall mounting only. For safe
installation it is essential to use hardware appropriate for your
wall type. Mount to wood wall studs whenever possible. If
you are unsure of what type of fasteners to use, consult your
local hardware store or a qualified professional. This product
is only deterrent, it is not a substitute for proper adult
supervision.
5 A. Place frame in desired location
against the wall and mark the
location of the holes in each bracket.
B. Wrap 2 wall straps around the
rear verticals of the main frame as
shown.
C. Pre-drill 1/4"diameter pilot holes
in the wall corresponding to the
holes in the straps.
D. Insert 2 drywall anchors into the
holes until the head is flush with the
surface of the wall. Gently tap into
position with a hammer if necessary.
E. Insert 1 screw through each wall
strap and into the drywall anchor.
Secure each screw with a phillips
head screwdriver.
Page 2 of 2
Loading...