Crate & Barrel Felix Office Chair Assembly Instruction
FELIX OFFICE CHAIR
HARDWARE
Thank you for purchasing the Felix Office Chair. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
COMPONENTS
2 - rubber
washers
Missing hardware?
Please call 800.606.6387 for replacements.
2 - small
bolts
2 - large
bolts
TOOLS REQUIRED
allen wrench (included)
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners.
rubber
washers
1 - seat
1 - seat
adjuster
1 - base
Made in Taiwan - r04 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
1 - gaslift
5 - casters
seat
1 Place seat upside down onto a clean, padded surface
as shown. Place 2 rubber washers onto seat as shown.
FELIX OFFICE CHAIR
small bolt
A
A
NOTE: Make
B
sure arrow on
adjuster points
towards front
edge of seat
B
gas
lift
FRONT
large bolt
B
2 A) Attach seat adjuster to seat as shown. Make
sure arrow on adjuster points toward the front edge of
the seat. Secure seat adjuster with 2 small bolts as
shown, using an allen wrench.
B) Secure seat adjuster to seat with 2 large bolts as
shown.
VIEW FROM
BELOW
OPERATING
INSTRUCTIONS
base
A
caster
3 A) Firmly press fit the stems of 5 casters into holes on
the underside of the base.
B) Fit bottom of gas lift into hole of base as shown.
1
2
1 HEIGHT ADJUSTMENT:
While sitting in the chair, pull the lever
up to lower the seat. To raise the seat,
take your weight off the chair and pull the lever up.
2 LOCKING THE SEAT:
While sitting in the chair, lean your weight forward
and push the lever in.
3 UNLOCKING THE SEAT:
While sitting in the chair, lean you weight forward and
4 Fit top of gas lift into corresponding hole
on the bottom of the seat assembly as
shown.
NOTE: Finalize assembly by sitting heavily
on the chair a few times. This will secure
all the component connections.
Made in Taiwan - r04 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
pull the lever out.
4 ADJUSTING THE TENSION:
Tighten the knob to increase the back tension (less
rocking). Loosen the knob to decrease the back
tensions (more rocking).
3
4
Loading...