ELLIS NIGHTSTAND
HARDWARE
Thank you for purchasing the Ellis Nightstand. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or
padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
14 - bolts
14 - spring
washers
8 - screws
Missing hardware?
Please call 800.606.6387 for replacements.
TOOLS REQUIRED
Phillips head screwdriver
14 - flat
washers
1 - back panel1 - front frame 1 - left side panel
1 - shelf panel1 - top panel
1 - drawer back panel 1 - drawer front panel 1 - drawer bottom panel
Made in Vietnam R02 Page 1 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
1 - drawer left
side panel
1 - right side panel
1 - drawer right
side panel
ELLIS NIGHTSTAND
Make sure the wheels
face towards
the front.
Note: Do not over
tighten the bolts.
1 Carefully lay back panel on padded surface. Fit
left and right side panel onto back panel by aligning
pre-assembled dowels with corresponding holes.
Secure with 4 bolts, 4 spring washers, and 4 flat
washers. Secure with Phillips head screwdriver but
do not over tighten.
2 Fit front frame onto assembled unit as shown by
aligning dowels with corresponding holes. Secure
front frame with 4 bolts, 4 spring washers and 4 flat
washers using a Phillips head screwdriver.
3 With the assistance of another adult, carefully
place unit upright. Fit top panel onto assembled unit
as shown by aligning dowels with corresponding
holes. Secure with 6 bolts, 6 spring washers, and 6
flat washers using a Phillips head screwdriver.
shelf panel
Note: Make sure larger
notch is at back of panel.
4 Fit shelf panel into position by inserting at an
angle and place into assembled unit as shown.
Make sure larger notch is at back of panel.
Made in Vietnam R02 Page 2 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
ELLIS NIGHTSTAND
Make sure the wheels of the
drawer slides face out and
towards the back
4 Attach the drawer left side panel to the drawer
front panel and drawer back panel with 4 screws.
Secure with a Phillips head screwdriver.
5 Slide drawer bottom panel into the groove at
the base of the assembly.
7 Insert drawer assembly into the case, fitting
wheels of drawer glide into rail of case glides.
Assembly is now complete.
CLEANING AND CARE
6 Attach the drawer right side panel to the
assembly with 4 screws. Secure with a Phillips
head screwdriver.
Made in Vietnam R02 Page 3 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Loading...