Crate & Barrel Delano Bookcase Assembly Instruction

DELANO BOOKCASE

ASSEMBLY HARDWARE

Thank you for purchasing the Delano Bookcase. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

TOOLS REQUIRED

allen wrench (included)

phillips head screwdriver

( We recommend the use of hand tools instead of power tools )

20 - spring
washers

washers

20 - bolts20 - flat

WALL MOUNTING HARDWARE

1 - wall strap 1 - small

screw

Missing hardware? Please call 800.606.6387 for replacements.

1 - large
screw

2 - wall
brackets

1 - drywall
anchor

COMPONENTS

1 - top shelf

1 - bottom shelf 3 - shelves

4 - uprights

ASSEMBLY

With the assistance of another adult, attach 2
uprights to top shelf, shelves and bottom shelf as
shown. Loosely attach shelves to each upright with 1
bolt, 1 spring washer and 1 flat washer as shown.

Repeat steps for remaining 2 uprights as shown.

Carefully position unit upright and fully tighten all
bolts with an allen wrench.

Assembly is now compete.

NOTE: Do not over
tighten the bolts

upright

top
panel

shelf

shelf

shelf

bottom
panel

Made in China - r05 Page 1 of 2

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

DELANO BOOKCASE

F

WALL

A

C

D

OPTIONAL WALL MOUNTING INSTRUCTIONS

For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.

A) Attach 1 wall bracket to assembled unit as shown,
using 1 small screw.
B) Determine the final location of unit. Mark position on the
wall, approximately 2" below the bracket mounted to the
back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Insert drywall anchor into hole
and secure using a phillips screwdriver.
D) Attach the wall bracket to the wall by inserting 1 large
screw through the wall bracket and into the drywall anchor
in the wall.
E) Place the unit so the wall bracket on the back edge is
aligned with the wall bracket on wall.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.

NOTE: If you are unsure about your
wall type or what mounting method
you should use, consult a qualified
professional or your local hardware
store.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Do not use
furniture wax or polish as the wood is finished
with a protective clear lacquer.

Wall mounting assembly is now complete.

Made in China - r05 Page 2 of 2

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com