Crate & Barrel Bungalow Bench Assembly Instruction
BUNGALOW BENCH
HARDWARE
Thank you for purchasing the Bungalow Bench. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
6 - bolts
4 - wood
dowels
Missing hardware? Please call 800.606.6387 for replacements.
6 - flat
washers
2 - barrel
screws
6 - spring
washers
2 - barrel
nuts
TOOLS REQUIRED
allen wrench (included)
flat head screwdriver
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
NOTE: Make sure
holes of each
barrel nut aligns
with nearest edge
with holes
1 - seat
2 - leg frames
(1 left, 1 right)
1 - crossbar
Made in China - r02 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
A
B
1 A) Insert 4 wood dowels into crossbar as shown.
Using a phillips head screwdriver, remove set screws
from barrel nuts and set aside until further instructions.
Insert 2 barrel nuts into crossbar as shown. With a
flat head screwdriver, make sure holes of each barrel
nut aligns with nearest hole on edge.
B) Insert 1 barrel screw into right and left leg frames as
shown. Secure, but do not over tighten, barrel screws
with a phillips head screwdriver.
BUNGALOW BENCH
2 Fit dowels of crossbar into corresponding holes of left
and right leg frames as shown. Make sure barrel screws
are fully engaged in barrel nuts. Insert set screws back
into barrel nuts. Using a phillips head screwdriver, turn
screws clockwise to secure.
CLEANING & CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
unit is finished with a protective clear lacquer. It is recommended to use coasters (without rubber feet) to protect
surface from heat and water.
3 Position leg assembly upright as shown. Fit seat onto
leg assembly and attach with 6 bolts, 6 spring washers
and 6 flat washers. Secure, but do not over tighten,
bolts with an allen wrench.
Assembly is now complete.
Made in China - r02 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...