Crate & Barrel Bristol 55 Wall Shelf Assembly Instruction

BRISTOL 55” WALL SHELF

HARDWARE

Thank you for purchasing the Bristol 55” Wall Shelf.
This page
take the time to identify the hardware as well as the
individual components
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.

lists all the contents included in the box. Please

to this product. As you unpack

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners.

2 - set screws

(pre-attached
to shelf)

10 - bolts

(for drywall)

TOOLS REQUIRED

phillips head screwdriver

allen wrench (included)

level drill

1 - metal
support

10 - anchors

(for drywall)

10 - screws

(for brick)

Missing hardware?
Please call 800.606.6387
for replacements.

10 - anchors

(for brick)

WEIGHT LIMITATION

This item is able to support up to a total of 80 lbs.

INSTALLATION INSTRUCTIONS

B

C

metal
support

For safe mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall, concrete,
brick, etc.). Mount to wood studs whenever possible. The
following instructions are for drywall mounting only:

D

A

WALL

NOTE: If you are
unsure about your
wall type or what
mounting method
you should use,
consult a qualified
professional
or your local
hardware store.

WALL

Made in China - r05 Page 1 of 1

metal
support

E

F

wall shelf

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

A. Determine where you wish to hang the wall shelf.
Using a level, position the metal support until it is
level and mark the 10 hole locations onto the wall.

Set metal support aside until further instructions.
B. Drill 10 pilot holes into marked positions on the wall
and into a wall stud. If the wall stud is not available, drill
a hole at each mark slightly smaller than the diameter of
the anchor.
C. Insert 10 anchors into holes. Make sure the flange
of each anchor is flush with the wall.
D. Align metal support with corresponding anchors in
wall. Fasten 10 bolts with a phillips head screwdriver
through metal support and into anchors.
E. Loosen and remove set screws; set aside. Fit pegs
of metal support into corresponding holes of wall shelf
as shown.
F. Re-insert set screws into bottom of shelf and secure
with an allen wrench.

Installation is now complete.