Crate & Barrel Bristol 28 Wall Shelf Assembly Instruction
BRISTOL 28” WALL SHELF
HARDWARE
Thank you for purchasing the Bristol 28” Wall Shelf.
This page
take the time to identify the hardware as well as the
individual components
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
lists all the contents included in the box. Please
to this product. As you unpack
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners.
2 - set screws
(pre-attached
to shelf)
6 - bolts
(for drywall)
TOOLS REQUIRED
phillips head screwdriver
allen wrench (included)
level drill
1 - metal
support
6 - anchors
(for drywall)
6 - bolts
(for brick)
Missing hardware?
Please call 800.606.6387
for replacements.
6 - anchors
(for brick)
WEIGHT LIMITATION
This item is able to support up to a total of 40 lbs.
INSTALLATION INSTRUCTIONS
C
B
metal
support
For safe mounting, it is essential to use wall anchors
appropriate to your wall type (i.e. plaster, drywall, concrete,
brick etc.). Mount to wood studs whenever possible. The
following instructions are for drywall mounting only:
A
A. Determine where you wish to hang the wall shelf.
D
WALL
NOTE: If you are
unsure about your
wall type or what
mounting method
you should use,
consult a qualified
professional
or your local
hardware store.
WALL
Made in China - r05 Page 1 of 1
metal
support
E
F
wall shelf
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Using a level, position the metal support until it is
level and mark the 6 hole locations onto the wall. Set
metal support aside until further instructions.
B. Drill 6 pilot holes into marked positions on the wall
and into a wall stud. If the wall stud is not available, drill
a hole at each mark slightly smaller than the diameter of
the anchor.
C. Insert 6 anchors into holes. Make sure the flange of
each anchor is flush with the wall.
D. Align metal support with corresponding anchors in
wall. Fasten 6 bolts with a phillips head screwdriver
through metal support and into anchors.
E. Loosen and remove set screws; set aside. Fit pegs
of metal support into corresponding holes of wall shelf
as shown.
F. Re-insert set screws into bottom of shelf and secure
with an allen wrench.
Installation is now complete.
Loading...