BOULEVARD II FOUR DRAWER CHEST
HARDWARE
Thank you for purchasing the Boulevard II Four Drawer
Chest. This page lists all the contents included in the
box. Please take time to identify the hardware as well as
the individual components of this product. As you
unpack and prepare for assembly, place the contents on
a carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this
product.
COMPONENTS
8 - bolts
4 - wood dowels 4 - drawer pulls
Missing hardware? Please call 800.606.6387 for replacements.
6 - wood
screws
8- pull
screws
32 - shoulder
screws
TOOLS REQUIRED
Allen Wrench (included)
Phillips Head Screwdriver
1 - top panel
1 - front rail
4 - drawer fronts
2 - side frames
(1 left, 1 right
4 - drawer backs 8 - drawer sides
Made in Thailand r04 Page 1 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
1 - back rail
1 - back panel
4 - drawer bottoms
(4 right, 4 left)
BOULEVARD II 4 DRAWER CHEST
NOTE:
Do not over
tighten
the bolts
Back Rail
Front Rail
1 Place left side panel face down on a padded surface.
Place the front and back rails into position as shown and
attach with 1 bolt per rail. Secure, but do not over tighten
each bolt with the allen wrench.
A
B
2 Place back panel into position and attach with 3 wood
screws. Secure with a phillips head screwdriver.
3 A) With the assistance of another adult, carefully place the
right side panel into position. Secure front and back rails
with 2 bolts and fully tighten with the allen wrench.
B) Insert 4 wood dowels into the top of each leg.
Made in Thailand r04 Page 2 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
4 With the assistance of another adult, carefully place
assembly upright. Fit top panel onto dowels on the top of
each leg. Attach back panel to top with 3 wood screws.
Attach each side panel to top with 2 bolts.
BOULEVARD II 4 DRAWER CHEST
A
B
5 A) Attach the drawer left side panel to the drawer front
and drawer back with 4 shoulder screws. Secure with a
Phillips head screwdriver, but do not over tighten.
B) Slide drawer bottom panel into the groove at
the base of the assembly.
7 Fit drawer glide hardware into corresponding large glide
hardware on the case interior. Applying even pressure to each
side of the drawer front, firmly push drawer into case glides. If
the drawer fronts are not aligned, minor vertical adjustments
can be made by loosening the drawer glide screw as shown.
Assembly is now complete.
6 A) Attach right drawer side with 4 shoulder
screws.
B) Attach drawer pull with 2 pull screws. Secure
screws with a phillips head screwdriver.
Repeat Steps 5 and 6 for the remaining 3 drawers.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.
Made in Thailand r04 Page 3 of 3
Customer Service 800.967.6696 | www.crateandbarrel.com
Loading...