Crate & Barrel Belmont Work Table with Stainless Steel Top Assembly Instruction
BELMONT WORK TABLE WITH STAINLESS STEEL TOP
HARDWARE
Thank you for purchasing the Belmont Work Table
with Stainless Steel Top. This page lists all the
contents included in the box. Please take time to
identify the hardware as well as the individual components of this product. As you unpack and prepare for
assembly, place the contents on a carpeted or padded
area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
B
12 - allen
bolts
8 - spring
washers
Missing hardware?
Please call 800.606.6387 for replacements.
8 - hex
bolts
4 - plastic
washers
TOOLS REQUIRED
hex wrench (included)
NOTE: Do not fully
tighten the bolts
fixed shelf
8 - flat
washers
allen wrench (included)
1 - tabletop
A
A
1 - shelf
4 - legs
(2 - labeled A,
2 - labeled B)
1 - crossbar
Made in Thailand - r03 Page 1 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
1 Fit notched corners of shelf into1 leg (A) and 1
leg (B) as shown. Loosely attach each leg with 1 hex
bolt, 1 spring washer and 1 flat washer. Do not fully
tighten bolts.
leg
B
B
leg
A
BELMONT WORK TABLE WITH STAINLESS STEEL TOP
crossbar
fixed shelf
leg
A
leg
B
2 Fit pre-assembled dowels of crossbar into legs as
shown. Loosely attach crossbar to each leg with 1 hex
bolt, 1 spring washer,1 flat washer and 1 plastic washer.
Do not fully tighten bolts.
leg
B
STEP 1
leg
A
fixed
shelf
crossbar
STEP 2
3 Step 1) Fit remaining leg (A) and leg (B) onto corre-
sponding notches of fixed shelf and dowels of crossbar.
Loosely attach each leg with 1 hex bolt, 1 spring washer
and 1 flat washer. Do not fully tighten bolts.
Step 2) Loosely attach crossbar to each leg with 1 hex
bolt, 1 spring washer,1 flat washer and 1 plastic washer.
BA
tabletop
NOTE: Do not remove
protective film until instructed
4 Place tabletop upside down onto a clean, padded
surface. With the assistance of another adult, position leg
assembly onto tabletop as shown. Attach each leg with
3 allen bolts. Secure, but do not over tighten, the bolts
with an allen wrench.
NOTE: Do not over
tighten the bolts
5 At this point, fully tighten all hex bolts with a
hex wrench. Do not over tighten bolts.
Made in Thailand - r03 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...