ARBOR RECTANGULAR DINING TABLE
Thank you for purchasing the Arbor Rectangular
Dining Table. This page
in the box. Please take the time to identify the
hardware as well as the individual components
product. As you unpack and prepare for assembly,
place the contents on a carpeted or padded area to
protect them from damage.
Note: 2 people are required to safely assemble this
product.
lists all the contents included
HARDWARE
8 - nuts 8 - washers 1 - umbrella cap
Missing hardware?
Please call 800.606.6387 for replacements.
TOOLS REQUIRED
to this
Hex wrench (included)
COMPONENTS
1 - table top
4 - legs
Made in Vietnam R03 Page 1 of 2
1
With the assistance of another adult, carefully lay top
panel face down on padded surface.
ARBOR RECTANGULAR DINING TABLE
X4
2
Insert 4 legs into under side of table top, fitting
leg bolts through holes of corner blocks.
3
Attach each leg with 2 washers and 2 nuts. Secure
each leg by turning all nuts clockwise with the
included hex wrench.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners.
Treat with Crate & Barrel's Hardwood Protector
or allow the finish to weather to a silvery gray.
4
With the assistance of another adult, place table
upright. If not using an umbrella, conceal hole
with the umbrella cap as shown. Assembly is
now complete.
Made in Vietnam R03
Page 2 of 2
ARBOR SMALL BENCH
HARDWARE
Thank you for purchasing the Arbor Small Bench. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this
product.
COMPONENTS
3 - crossbars
6 - large
bolts
Missing hardware?
Please call 800.606.6387 for replacements.
TOOLS REQUIRED
allen wrench (included)
NOTE: Do not fully tighten
the bolts until all bolts are
installed.
crossbar
2 - medium
bolts
4 - small
bolts
2 - leg frames
1 - seat
Made in VIetnam - r02
leg frame
1 Fit notches of each crossbar into corresponding
holes of 2 leg frames as shown. Loosely attach each
leg with 1 large bolt. Do not fully tighten the bolts
until all bolts are installed.
Customer Service 800.967.6696 | Latest instructions availabe at www.crateandbarrel.com
Page 1 of 2
ARBOR SMALL BENCH
leg assembly
IMPORTANT: During assembly, lift
both sections of leg assembly to
prevent damage as shown
A
B
seat
2 A) Fit notches of leg assembly into seat as shown.
Loosely attach corner legs with 4 small bolts.
B) Loosely attach center legs with 2 medium bolts.
At this point, fully tighten all bolts with an allen
wrench. Position unit upright.
Assembly is now complete.
A
B
NOTE: Do not fully tighten
bolts until all bolts are
installed.
Made in Vietnam- r02
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Treat with Crate
& Barrel's Hardwood Protector or allow the
finish to weather to a silvery gray.
Customer Service 800.967.6696 | Latest instructions availabe at www.crateandbarrel.com
Page 2 of 2
Loading...