ANTENNA BOOKCASE
HARDWARE
Thank you for purchasing the Antenna Bookcase.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect
them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
24 - small
bolts
2 - screws
Missing hardware? Please call 800.606.6387 for replacements.
8 - medium
bolts
2 - brackets
2 - large
bolts
4 - adjustable
feet
2 - plastic
anchors
20 - adhesive
pads
TOOLS REQUIRED
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
allen wrench (included)
5 - glass tops
1 - crossbar
1 - 1st shelf
1 - 2nd shelf
1 - 3rd shelf
1 - 4th shelf
1 - 5th shelf
2 - front legs
(1 left, 1 right)
2 - back legs
(1 left, 1 right)
Made in Taiwan - r03
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Page 1 of 3
ANTENNA BOOKCASE
1 A) Fit brackets of left front and back
legs into 5 shelves (in descending order)
as shown. Make sure holes on side of
each shelf corresponds with holes of left
front leg. Loosely attach each shelf with
1 medium bolt as shown with an allen
wrench. Do not fully tighten bolts until all
bolts are installed.
B) Repeat step 1A for right front and
back legs as shown.
NOTE: Do not fully
tighten the bolts until
all bolts are installed
A
A
crossbar
right front
leg
right back
leg
B
left front
leg
left back
leg
A
5th shelf
4th shelf
3rd shelf
2nd shelf
1st shelf
A
B
B
B
adhesive
pad
B
adjustable
foot
A
2 A) With the assistance of another adult, position
assembly upright. Loosely attach crossbar to assembled
unit with 2 large bolts as shown.
B) Insert 24 small bolts into shelves as shown. At this
point, fully tighten bolts with an allen wrench.
Made in Taiwan - r03 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
3 A) Attach 4 adjustable feet to assembled unit as shown.
B) Attach 4 adhesive pads to each shelf as shown.
ANTENNA BOOKCASE
OPTIONAL WALL MOUNTING ASSEMBLY
A
glass top
B
bracket
B
5 A) Carefully remove 1st glass top and set aside.
Remove 2 inside small bolts from 1st shelf and attach
brackets to 1st shelf. Reattach with 2 small bolts and
replace glass top.
B) Determine final location of unit. Mark position on the
wall and drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap each plastic anchor
4 Carefully place 1 glass top onto each shelf. Make sure
each glass top is securely supported by each adhesive
pad.
Assembly is now complete.
until the flange of each anchor is flush with the wall. Attach
brackets to the wall by inserting 1 screw through each
bracket and into each plastic anchor in the wall.
Wall mounting assembly is now complete.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners.
Made in Taiwan - r03 Page 3 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...