Crate & Barrel Alto Wine Table Assembly Instruction

ALTO WINE TABLE

HARDWARE

Thank you for purchasing the Alto Wine Table. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or padded
area to protect them from damage.
Note: 2 people are required to safely assemble this
product.

COMPONENTS

4 - wood screws

16 - shelf pins

Missing hardware? Please call

4 - tube caps

800.606.6387 for replacements.

TOOLS REQUIRED

Allen wrench (provided)

Phillips head screwdriver

A

16 - machine screws

4 - flat washers

2 - side frames

Made in China - r03

1 - wood top

4 - wine racks

1 - top crossbar

1 - base frame

1 - glass rack

B

x 2

C

1 A. Lay 1 side frame face down with the tube fittings
facing up, oriented as shown. Slide top crossbar and glass
rack over tube fittings as shown. Make sure holes in rails and
tube fittings are aligned and face towards the inside.
B. Loosely attach frames with 2 machine screws per rail. Do
not fully tighten the screws.
C. Insert 8 shelf pins into threaded holes in side frame and
secure with the allen wrench.

Page 1 of 2

ALTO WINE TABLE

B

A

Install at a slight angle,
inserting pins into shelves
one shelf at a time

2 A. Attach base frame to assembly with 2 machine
screws per rail, using same method outlined in Step 1.
B. Place 4 wine racks into position, fitting open tubes of
shelf ends onto pins of side frame.

3 Insert 8 shelf pins into remaining side frame and fit into
position. Install side frame at a slight angle, fitting pins into
shelves one at a time. Secure with 8 machine screws.

A

x 16

B

5 A. With the assistance of another adult, lift assembled unit
into an upright position. Place wood top into position. Insert 4
wood screws and 4 washers through each metal tab on the
crossbars and secure with a phillips head screwdriver.
B. At this point, fully tighten all machine screws installed in
Steps 1 - 3 with the allen wrench. Assembly is now complete.

4 Insert 1 plastic tube cap onto bottom of each leg. If
necessary, gently tap into place with a hammer.

Made in China - r03

CARE & CLEANING

Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.

Page 2 of 2