Crate & Barrel Alpha Table Assembly Instruction

ALPHA TABLE

HARDWARE

Thank you for purchasing the Alpha Table. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and
prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.

COMPONENTS

6 - flat
washers

3 - screw
posts

6 - spring
washers

6 - bolts

3 - barrel
nuts

Missing hardware?
Please call 800.606.6387
for replacements.

3 - set
screws

TOOLS REQUIRED

allen wrench (included)

phillips head screwdriver

flat head screwdriver

(We recommend the use of hand tools instead of power tools)

ASSEMBLY

1 - tabletop

1 - crossbar
assembly

3 - legs

NOTE: Do not over

tighten screw posts

NOTE: Make sure to

leg

1 Place leg onto a clean, padded surface. Insert 1

screw post into each leg and secure with a flat head
screwdriver. Note: Make sure to align slot on top of

screw post parallel to leg. Do not over tighten screw
posts. Repeat for remaining legs.

align slot of screw post
parallel to leg

Made in Vietnam - r02 Page 1 of 2

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

ALPHA TABLE

Align this hole
with hole on end
of crossbar

crossbar
assembly

2 Place crossbar assembly onto a clean, padded surface.
Insert 3 barrel nuts into crossbar assembly as shown.
Use a flat head screwdriver to align the hole on the side
of the barrel nut with the hole on the end of each crossbar.

bolt

spring washer

flat washer

NOTE: Do not over
tighten the bolts

leg

tabletop

3 Place tabletop onto a clean, padded surface. Attach 1
leg to tabletop with 2 flat washers, 2 spring washers
and 2 bolts as shown, using an allen wrench. Do not over
tighten the bolts.

B

B

A

4 A) Fit pre-assembled wood dowel of crossbar into
corresponding hole of leg. Make sure hole in screw post aligns
with hole on end of crossbar.
B) Secure crossbar assembly to leg by inserting a set screw
into barrel nut. Tighten with a phillips head screwdriver,
making sure set screw securely engages the screw post of the
leg.

crossbar
assembly

CORRECTLY ASSEMBLED

SIDE VIEW DETAIL

set screw

barrel nut

screw post

leg

leg

5 Repeat steps 3-4 for remaining legs as shown.
Position unit upright. Assembly is now complete.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do
not use abrasive cleaners. Do not use furniture wax
or polish as the wood is finished with a protective
clear lacquer. It is recommended to use coasters to
protect surface from heat and water.

Made in Vietnam - r02 Page 2 of 2

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com