Crate & Barrel Alden Full Bed, Alden Queen Bed Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

ALDEN FULL, QUEEN BED

Thank you for purchasing the Alden Full or Queen
Bed. This page lists all the contents included in the

box. Please take time to identify the hardware as
well as the individual components of this product. As
you unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect
them from damage.
Note: 2 people are required to safely assemble this
product.

COMPONENTS

1 - headboard

1 - footboard

2 - side rails
(1 right, 1 left)

1 - center
rail

1 - adjustable
support
leg

Made in Thailand - r04

1 - slat
assembly

HARDWARE

4 - small screws

8 - flat washers 8 - split washers

Missing hardware? Please call 800.606.6387 for replacements.

6 - large screws 8 - bolts

TOOLS REQUIRED

Allen Wrench (included)

Phillips Head Screwdriver

x 2

1 With the assistance of another adult, fit dowels of side
rails into corresponding holes in headboard. Insert 2 bolts,

2 split washers and 2 flat washers through holes in each
metal bracket and into the headboard. Fully tighten each bolt
with the allen wrench.

Page 1 of 2

Customer Service 800-967-6696 | http://www.crateandbarrel.com

ALDEN FULL, QUEEN BED

x 2

2 Attach foot board to each side rail with 2 bolts, 2
split washers and 2 flat washers. Secure all bolts with

the allen wrench.

4 Fit metal brackets at ends of center rail into metal
bracket on head and foot boards. Firmly press each end
into position until brackets are snugly engaged.

Made in Thailand - r04

Metal brackets
face down

3 Fit bracket of adjustable support leg onto center rail,
aligning corresponding holes. Make sure brackets at rail
ends face down as shown. Attach with 4 small screws and
secure with a phillips head screwdriver.

5 Place slat assembly onto support ledge on inside of
each side rail, aligning holes in slats with holes in support
ledge. Secure with 6 large screws, fully tightening each with
a phillips head screwdriver.
To compensate for uneven floors, adjust leveler on adjustable
support leg as necessary.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.

Page 2 of 2