Page 1
Page 2
CRATE TAXI •
TX15
2
CONGRATULATIONS!
You are now the proud owner of the Crate TX15 battery powered amplifier. At last, you can take your music with you and have great tone on the
road. The TX15 is compact and portable, with two inputs and the incredible sound that has made Crate a household name among musicians.
Like all Crate products, your TX15 is designed by musicians and built
using the finest components available. Each unit is rigorously tested by
skilled technicians and musicians to ensure that your amplifier is the best
it can be!
In order to get the most out of your new amplifier, please read this
manual before you begin playing.
And Thank You for choosing
CRATE.
CONTENTS:
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Suggested Setup . . . . . . . . . . . . . . . . . . . . . .3
About the Power Supply . . . . . . . . . . . . . . . . .4
The Front Panel . . . . . . . . . . . . . . . . . . . . . . .5
The Rear Panel . . . . . . . . . . . . . . . . . . . . . . .6
System Block Diagram . . . . . . . . . . . . . . . . . .7
Technical Specifications . . . . . . . . .back cover
IMPORTANT SAFETY INSTRUCTIONS
• READ, FOLLOW, HEED, AND KEEP ALL INSTRUCTIONS AND WARNINGS.
• DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. FOR
PROPER OPERATION, THIS UNITREQUIRES 3” (75mm) OF WELL VENTILATED SPACE AROUND HEATSINKS AND OTHER AIR
FLOW PROVISIONS IN THE CABINET.
• DO NOT USE THIS APPARATUS NEAR SPLASHING, FALLING, SPRAYING, OR STANDING LIQUIDS.
• CLEAN ONLY WITH LINT-FREE DAMP CLOTH AND DO NOT USE CLEANING AGENTS.
• ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND
COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS.
• PROTECT THE POWER CORD FROM DAMAGE DUE TO BEING WALKED ON, PINCHED, OR STRAINED.
• UNPLUG THE APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME.
• ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERA-
TION AND TO AVOID INJURY.
• THIS APPARATUS DOES NOT OPERATE NORMALLYAND REQUIRES SERVICE WITH ANY PHYSICAL DAMAGE FROM IMPACT OR
ANY EXPOSURE TO MOISTURE.
• SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL.
• OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND
PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"
“ES NECESARIO QUE EL USUARIO SE REFIERA AL MANUAL DE INSTRUCCIONES.”
"REFERREZ-VOUS AU MANUAL D'UTILISATION"
EXPLANATION OF GRAPHICAL SYMBOLS:
EXPLICACION DE SIMBOLOS GRAFICOS:
EXPLICATION DES SYMBÔLES GRAPHIQUES:
"DANGEROUS VOLTAGE"
“VOLTAJE PELIGROSO”
"DANGER HAUTE TENSION"
=
=
PRECAUCION
RIESGO DE CORRIENTAZO
NO ABRA
PRECAUCION: PARA REDUCIR EL RIESGO DE INCENDIOS O DESCARGAS
ELECTRICAS, NO PERMITA QUE ESTE APARATO QUEDE EXPUESTO A LA
LLUVIA O LA HUMEDAD. PARA DISMINUOIR EL RIESGO DE CORRIENTAZO.
NO ABRA LA CUBIERTA. NO HAY PIEZAS ADENTRO QUE EL USARIO PUEDO
REPARAR DEJE TODO MANTENIMIENTO A LOS TECHNICOS CALIFICADOS.
ATTENTION
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
ATTENTION: PROTÉGEZ CET APPAREIL DE LA PLUIE ET DE L'HUMIDITÉ
AFIN D'ÉVITER TOUT RISQUE D'INCENDIE OU D'ÉLECTROCUTION. POUR
REDUIRE D'ELECTROCUTION NE PAS ENLEVER LE COUVERCLE. AUCUNE
PIECE INTERNE N'EST REPRABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.
Page 3
CRATE TAXI •
TX15
FEATURES:
• Two input channels for connecting microphones (high and low Z) and instruments
• CD input jacks for connecting a CD or tape player, rhythm machine or other
background source
• Headphones jack for listening in private
• Internal rechargeable power supply provides a minimum of 8 hours normal
playing time – fully recharges within 6 hours
• Charger doubles as AC wall adapter to conserve battery
• Two-color battery status LED: red indicates low battery, yellow indicates
battery is okay
• Tuned port cabinet for extended bass response, 8” woofer and 2” Piezo
tweeter for full range sound with clear highs
• Durable high-visibility safety yellow or low-profile black Tolex
®
covering
• Rubber feet on three different sides for positioning as either a low angle
monitor, high angle monitor or upright speaker (see below)
SUGGESTED SETUP:
3
LOW ANGLE MONITOR HIGH ANGLE MONITOR UPRIGHT SPEAKER
LOW OR
HIGH Z MIC
CD PLAYER, TAPE PLAYER
GUITAR,
KEYBOARD,
OR OTHER
INSTRUMENT
EFFECTS
OR DRUM MACHINE
OUT
L OUT
R OUT
INPUT 1
INPUT 2
CD INPUT
Page 4
CRATE TAXI •
TX15
4
ABOUT THE POWER SUPPLY:
The TX15 uses a sealed lead-acid 12-volt battery as its internal power
source. Unlike ni-cad batteries, this battery has no “memory” – it can
be fully recharged at any time, without damage to the battery.
When fully charged, the LED next to the power switch will illuminate
yellow with the switch in the on position. The LED will change to red
when the battery is low and needs recharging. When this happens, turn
the amp off, connect the 15-volt charger to the charger jack and plug it
in to an AC outlet. The LED near the charger jack will illuminate red
while the amp is charging and goes out when the amp is fully charged.
The battery fully recharges within 6 hours, providing at least 8 hours of
use at low levels, about 4 hours of use at moderate levels, and about 2
hours of use at continuous full power (sine wave). The battery is rated
for up to 1000 charging cycles. (The charger can also function as an AC
power supply.)
The battery inside the TX15 must be fully charged before operating the
amplifier for the first time. The amplifier leaves our factory with a
charged battery. However, the battery may lose some of its charge in
transit.
NOTE: If the battery is drained too low, the Power LED will go out. This
indicates an exhausted battery – one which may not take a charge. If
this happens, turn the amp off, connect the 15-volt charger to the
charger jack and plug it in. If the Charger LED (see #14, page 6) doesn’t
illuminate, the battery might be beyond recharging. (The TX15 uses a
“smart” charging circuit and will not allow you to charge a defective
battery.) If the battery is serviceable, the LED will illuminate once the
battery reaches 10 volts – leave the charger plugged in and let the battery fully recharge. If the LED never illuminates, the battery may need
replacing. Contact Crate’s service department:
SLM Electronics
1901 Congressional Drive
St. Louis, MO 63146
1-800-738-PARTS (7563)
CAUTION! The TX15 contains a sealed, rechargeable,
lead-acid battery. Improper disposal of battery or replace-
ment with any other type may cause leakage, explosion,
and/or injury. Refer also to the warranty card.
Page 5
CRATE TAXI •
TX15
5
1. INPUT 1: Use this jack to connect
a low or a high impedance microphone to the amplifier by means of
a shielded signal cable.
2. VOLUME 1: Use this control to
adjust the level of the signal connected to the Input 1 jack (#1).
3. INPUT 2: Use this jack to connect an instrument or a high
impedance microphone to the
amplifier by means of a shielded
instrument or signal cable.
4. VOLUME 2: Use this control to
adjust the level of the signal connected to the Input 2 jack (#3).
5. LOW: Use this control to adjust
the level of the low frequencies for
both inputs.
6. LOW MID: Use this control to
adjust the level of the lower-middle
frequencies for both inputs.
7. HIGH MID: Use this control to
adjust the level of the upper-middle frequencies for both inputs.
8. HIGH: Use this control to adjust
the level of the high frequencies
for both inputs.
9. CD INPUT: Use these jacks to
connect the output of a CD player,
a tape player, a rhythm machine or
any other similar source to the
amplifier by means of a shielded
signal cable. These jacks are connected in parallel – a stereo signal
should be connected to both jacks
(the left channel to one jack, the
right channel to the other), while a
mono signal may be connected to
either jack.
10. HEADPHONES: Use this jack to
connect a pair of stereo headphones to the amplifier. The internal speaker is disconnected when
the headphones jack is used.
11. LED: When the power switch is
on and the battery is fully charged,
this LED illuminates yellow. The
LED illuminates red when the battery needs recharging.
12. POWER: Use this switch to turn
the amplifier on (top of the switch
depressed) and off (bottom of the
switch depressed).
THE FRONT PANEL:
Page 6
CRATE TAXI •
TX15
6
13. DC CHARGER PLUG: Use this
jack to connect the 15VDC charger
to the amplifier to recharge the
battery (power switch off) or to
supply power to the amplifier while
playing (power switch on). Plug the
charger into an AC outlet of the
proper voltage as listed on the
charger.
NOTE: The 15VDC charger will
recharge the amplifier’s battery
only when the amp is not being
played. If the amplifier is being
played while the charger is connected and plugged into a source
of AC power, the battery will neither charge or discharge.
14. LED: This LED illuminates when
the amplifier is being charged.
Once the battery is fully charged,
this LED should go out. (See page
4 for complete information on the
power supply.)
THE REAR PANEL:
Page 7
CRATE TAXI •
TX15
SYSTEM BLOCK DIAGRAM:
7
INPUT
1
13
2
INPUT
2
VOLUME
VOLUME
LIMITER
LO LO
POWER
AMP
TONES
MIDHIMID
HI
CD
INPUT
HEAD
PHONES
TWEETER
WOOFER
POWER SUPPLY
SMART
DC
CHARGER
CHARGER
CHARGING
CIRCUIT
CHARGING
INDICATOR
FUSE
BATTERY
BATTERY
INDICATOR
Page 8
©2001 SLM Electronics • A division of St. Louis Music
1400 Ferguson Avenue • St. Louis, MO 63133
P/N 47-297-01 • 11/01
CRATE TAXI •
TX15
TECHNICAL SPECIFICATIONS
OUTPUT POWER RATING 15W RMS @ 10% THD, 4 ohms, 13.6VDC in
INPUT IMPEDANCE 20k ohm
MAXIMUM SIGNAL ACCEPTED
Input 1 Hi-Z 8V peak to peak, 2.75V RMS
Input 1 Lo-Z 1.2V peak to peak, 40mV RMS
Input 2 8V peak to peak, 2.75V RMS
GAIN Input 1 Hi-Z 52dB, Lo-Z 68dB
Input 2 52dB
SENSITIVITY Input 1 Hi-Z 12mV RMS, Lo-Z 1.75mV RMS
Input 2 12mV RMS
EQS Low ±15dB @ 70Hz
Low Mid ±12dB @ 385Hz
High Mid ±10dB @ 1.85kHz
High ±15dB @ 10kHz
SPEAKERS Woofer Crate Custom 8”, 4 ohm, 15 watt, 1” voice coil
Tweeter 2” Piezo
POWER REQUIREMENTS Internal 12 volt DC power supply
DC adapter for use with 120VAC
SIZE AND WEIGHT 14.5”W x 11.75”H x 12”D; 20 lbs.
The TX15 is covered with a durable Tolex®material. To keep the cabinet in top condition, wipe it
clean with a damp, lint-free cloth to remove dirt and road film. Never spray cleaning agents
directly onto the cabinet. Do not use abrasive cleansers which could damage the finish.
Crate continually develops new products, as well as improves existing ones. For this reason,
the specifications and information in this manual are subject to change without notice.
www.crateamps.com
Declaration Of Conformity
#26, Effective 01-01-2001
Manufacturer’s Name: SLM Electronics
Production Facility: 11880 Borman Drive, St. Louis, MO 63146, USA
Production Facility: 700 Hwy 202 W, Yellville, AR 72687, USA
Shipping Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Office Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Product Type: Audio Amplifier
Complies with Standards:
LVD: 92/31/EEC, 93/68/EEC, & 73/23/EWG
Safety: EN60065
EMC: EN55013, EN55020, EN55022, EN61000-3-2,
& EN61000-3-3
Supplementary information provided by your local Sales & Services Office or:
SLM Electronics - R & D Engineering
1901 Congressional Drive, St Louis, MO 63146, USA
Tel.: 314-569-0141, Fax: 314-569-0175
Loading...