Craig CRT728C Owner's Manual
FCC INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide residential protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception. which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on the circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING:
The equipment may generate or use radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. Modifications not authorized by the manufacturer may void user’s authority to
operate this device.
GENERAL WARNINGS:
1. Important Instructions:
This product is suitable for 14 years old and above. Please read the instruction manual
before you play with this product.
2. Make sure the unit always within the Radio Frequency control range. Otherwise, the
unit will out of control and may crash.
3. Safety Instructions:
Keep away from the objects and crowds.
The unit is flying at high speed; keep it away from crowds, buildings, high voltage
wires, etc.
Do not operate this unit in bad weather.
Keep away from water and rain.
The unit has electronic and mechanical parts which may be damaged by water and
rain.
Keep away from the working unit.
The blades are turning in high speed, always keep away from it.
1
LOCATION OF CONTROLS:
Main Unit:
1. Blades
2. Camera Module/Battery Door
3. Camera
4. Connection Cable of Camera
5. Connection Jack of Camera
6. Blade’s Protectors
7. Landing Gears
8. Battery Compartment
9. Battery Connection Cable/Jack
10. Micro SD Card Slot
2
10
8
5
4
7
7
9
2
311
6
6
REMOTE CONTROL:
1. Power On/Off Button
2. Power On Indicator
3. Left Joystick/One Key Take Off - Landing Button
4. Right Joystick/One Key Emergency Stop Button
5. Headless - One Key Return Button
6. 3D Rolling Button
7. Speed Selection Button
8. Counterclockwise Fly Trimmer
9. Clockwise Fly Trimmer
10. Video Recording Button
11. Photo Capture Button
12. Left Fly Trimmer
13. Right Fly Trimmer
14. Forward Fly Trimmer
15. Backward Fly Trimmer
16. Battery Door (On the rear)
17. Security Screw of Battery Door
3
16
141513
12
10
11
987
6
524
3
1
17
PREPARATIONS:
Assembly the Landing Gears to the Main Unit:
The unit has 4 Landing Gears, insert it to the corresponding mounting holes on the unit before use
as illustrated below:
Battery Recharging:
The unit has a DC 3.7V Li-ion rechargeable battery. Recharge it before first time use or when it is
drained as follows:
1. Connect the small plug from the supplied USB Connect Cable to the jack from the Battery
Connection Cable.
2. Connect the full size USB plug from the cable to the USB Port on Personal Computer or USB
Charger (Computer and USB Charger not included) as illustrated below:
3. Charging will automatically start. The Red Charging Indicator Inside the full size USB Plug
will illuminate. When finished charging, the indicator will turn off.
4
Loading...