Craig CHT912 Owner's Manual

Meijer.com

WARNING:Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.

NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:

•

Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.

•

•

•

FCC Warnings

This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum 20 cm between the radiator and your body.
This transmitter must not be collocated or operating
in conjunction with any other antenna or transmitter
unless authorized to do so by the FCC.

Meijer.com

Meijer.com

Insert the small plug from the supplied AC/DC adapter to the DC in jack on the unit.
Insert the AC/DC adapter to DC in jack on the unit.

2. Mounting the Speaker Bar onto a wall

We recommend having this speaker professionally mounted. By using the included
wall mounting accessories, the sound bar can be mounted onto a wall.

Distance Between Two Brackets

1. Placing on the table

Ventilation
When placing the Sound Bar on an entertainment center, bookshelf, or any type of
enclosed space, be sure to allow at least 2-3 inches of space around the Sound Bar
for ventilation. If the Sound Bar is enclosed in a tight space, without ventilation, heat
generated from the Sound Bar could produce a potential heat hazard.

19.29 inches

AC/DC adapter

Meijer.com

2.1. Mounting on the wooden wall

You should use

1. Mark the position of the mounting screws on the wall using a pencil.

2.

Drill through the EVA with screw directly into the marks that you have made on the wall.

3. Put the sound bar onto the mounting brackets. Make sure they are firm and stable.

4

You may use

2.2. Mounting on the wall

2 pieces of plastic tubes

(Included)

2 pieces of short screws

(Included)

2 pieces of EVA

(Included)

2 pieces of short screws

(Included)

2 pieces of EVA

(Included)

Meijer.com

5

(1) (2)

1. Mark the position of the mounting screws on the wall using a pencil.

2. Drill 2 x 0.315” holes by a powerful electric drill.

3. Insert the supplied 2 plastic tubs into the holes by hammer.

4. Drill through the EVA with screws directly into the holes.

5.

Put the SOUND Bar onto the mounting brackets. Make sure they are firm and stable.

Meijer.com

1. REMOTE SENSOR: Ensure this area is not covered or blocked by any object.

2. STANDBY button: Press to turn the speaker bar off or on.

3.

SOURCE button: Press repeatedly to select the input sound to BT (Bluetooth receiver),

AUX, LINE in or FM.

4. VOLUME +: Press to increase volume.

5. VOLUME -: Press to decrease volume

6. MUTE: Press to mute the sound, press again to resume.

7. STANDBY Indicator.

8. FM Indicator.

9. BT Indicator.

10. AUX Indicator.

11. LINE IN Indicator.

12. FM antenna.

13. AUX L/R IN jacks.

14. 3.5mm LINE IN jack.

15. DC jack in.

16. Mounting bracket.

6

Meijer.com

1. STANDBY button: Press to turn the unit on or off.

2. BLUETOOTH button: Press to switch to Bluetooth mode.

3. SCAN button: Press to scan for available radio stations in FM Radio mode,
then store in the memory list automatically. Total 30 stations can be stored.

4. MUSIC button: Press to switch to the EQ optimized for music.

5. TREBLE buttons: Press to adjust the treble up or down.

6. AUX button: Press to switch to AUX mode.

7. MUTE button: Press to mute the sound, press again to resume.

8. LINE button: Press to switch to LINE In mode.

9. FM button: Press to switch to FM Radio mode.

10. CH + button: Press to skip to next stored channel.

11. CH - button: Press to skip to previous stored channel.

12. MOVIE button: Press to switch to the EQ optimized for movie sound.

13. VOICE button: Press to switch to the EQ optimized for dialogue.

14. BASS buttons: Press to adjust the bass up or down.

15. VOLUME buttons: Press to adjust the volume.

7

Meijer.com

8

PUSH

OPEN

CR2025

PUSH

OPEN

Lithium Cell

CR2025

3V

SC UL

Lithium Cell

CR2025

3V

SC UL

1. Push the tab, then slide out the battery tray as the
figure on the right.

2. Replace the old button cell by a new CR 2025
button cell as the polarity markings on the remote
control.

3. Close the battery tray.

To replace the button cell:

7.

Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old
batteries with fresh ones.

Meijer.com

9

Listening from AUX IN jacks:

1. Connect the Aux out jacks from the external audio player (such like DVD player, TV,
VCR …etc.) to the AUX IN jacks on the rear of Sound Bar by the supplied RCA
connection cable as the figure below:

2. Connect the Sound Bar to the power as previous procedures. The Standby indicator will
turn on.

3. Press the Standby ( ) button on the Sound Bar or Remote Control to power on
the Sound Bar.

4. Press the SOURCE button on the unit repeatedly or press the AUX button on the
Remote Control to turn to AUX mode. The AUX indicator will turn on.

5. Power on the connected external player and start playback as usual.

6. Press the volume buttons to adjust volume level.

7. Press the TREBLE buttons on the Remote Control to adjust treble as desired.

8. Press the BASS buttons on the Remote Control to adjust bass as desired.

9. Press the EQ preset mode buttons MUSIC; MOVIE or VOICE to turn on the preset
EQ effect as desired.

10. Press the MUTE button to turn off the sound, press again to resume.

11. When finished listening, press Standby ( ) button on the Speaker or Remote
Control to power Off (Standby mode) the Speaker.

1. Connect the Headphone/Earphone; Line out jacks from the external audio player
(such like MP3 player; Discman … etc) to the LINE IN jacks on the rear of Sound Bar
by the supplied Line In connection cable as the figure below:

LISTENING FROM LINE IN JACKS:

OPERATION:

Meijer.com

10

2. Connect the Sound Bar to the power as previous procedures. The Standby indicator
will turn on.

3. Press the Standby ( ) button on the Sound Bar or Remote Control to power on
the Sound Bar.

4. Press the SOURCE button on the unit repeatedly or press the LINE button on the
Remote Control to turn to LINE mode. The LINE indicator will turn on.

5. Power on the connected external player and start playback as usual.

6. Other operations are same as AUX IN mode.

LISTEN TO RADIO :

1. Power on the Sound Bar as previous procedures.

2. Press the SOURCE button on the unit repeatedly or press the FM button on the
Remote Control to turn to Radio (FM) mode. The FM indicator will turn on.

3. In first time: Press the SCAN button on the Remote Control to start auto searching
(It may take a few minutes). The available FM stations will be stored into internal
memory list. After scanning : Press the CH (Channel) + button to skip to next stored
channel, press the CH (Channel) – button to skip to previous stored channel. Repeat
the same procedures until the desired station are found and play.

4. Other operations are same as AUX IN mode.

BT PAIRING AND PLAYBACK:

1. Power on the Sound Bar as previous procedures.

2. Press the SOURCE button on the Sound Bar repeatedly or press the BT (Bluetooth)
button on the Remote Control to turn to BT mode. The BT indicator will turn on.

3. Turn on the BT function in the external BT player and wait a few seconds until the
external BT player and the speaker were paired. Play the music in the external BT
Player as usual.

4. Other operations are same as AUX IN mode.

NOTES:

1. In first time use, connect the external BT Player as below:
A. Turn the Sound Bar to BT mode as previous procedures, the BT indicator will turn
on and blinking.
B. Power on the external BT player and enter to BT searching mode. Start pairing as
the on screen instructions on the external BT Player (For details pairing procedures,
please refer to the user’s manual of your BT player.).
C. When the external BT player searched the Sound Bar, our model number “CHT912”
will appear on the display of external BT player.
D. Pairing code “0000” may need to enter.

Meijer.com

11

Problem What to do

No power Check the connection of the AC/DC adapter

between the speaker and wall outlet.

Check that the volume control is NOT at minimum

No sound

The remote control
won' t work

No sound from
in BT mode

Check that it is NOT set to mute.

Inspect or replace the battery.

Make sure there are no obstacles obscuring the
front of the Speaker.

Check if you have pairing or not. It needs to pair
the external BT player and the speaker with
password "0000" before 1st time listening.

1. Do not use harsh or abrasive cleaning agents or solvents.

2. Do not attempt to disassemble your product.

3. Do not paint your product.

4. Do not drop, throw or try to bend your product.

5. Do not expose your product to open flames.

Maintenance

Meijer.com

Power Source :……………………. DC 18V 2.5A ,
Power Source of Remote Control:……DC 3V, 1X CR 2025 battery (Included)
Power Consumption:…………………………………….>50W
Audio Power :

Woofer …………………………………............ 30W

Left Channel ……………………………...........10W

Right Channel………………………….............10W

Radio Coverage …..………………………...............…. FM 87.5-108.0 MHz

Impedance of Speakers :

Woofer ……………………………….….......… 8 Ohm,25W x 2

Left Channel …………………………….......... 4 Ohm,15W

Right Channel…………………………........…. 4 Ohm,15W

1 x User’s Manual
1 x Remote Control --- uses 1X CR 2025 button cell (Included)
1 x AC/DC Adaptor (Input: AC 100-240V~, 50/60 Hz, 1.5A;
Output: DC 18V, 2500mA, )
1 x RCA cable
1 x 3.5mm LINE In cable
2 x Screws
2 x Plastic Tubes
2 x EVA spacer

12

Meijer.com

Craig warrants this product to be free from manufacturing defects in material and
workmanship under normal use for a period of 90 days from date of purchase. If service
is required, please return the product to the store where it was purchased for exchange;
or, pack the unit in the original packing material with all accessories if applicable, a copy
of your sales receipt and a Cashier’s check or Money Order for $18.00 (to cover shipping
and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please
make sure that the cashier check or money order is redeemable through a U.S. bank.
Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can
not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt
of your unit. Please ship your unit to:

Craig Electronics Inc.

1160 NW 163 Drive

Miami, Fl 33169

This warranty is void if the product has been: a) Used in a commercial application or
rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by
anyone other than an authorized Craig service center. d) Damaged because it is
improperly connected to any other equipment.
Note: This warranty does not cover: a) Ordinary adjustments as outlined in the Owner’s
Manual which can be performed by the customer. b) Damage to equipment not properly
connected to the product. c) Any cost incurred in shipping the product for repair. d)
Damage to the product not used in the USA.

This warranty is not transferable and only applies to the original purchase. Any implied
warranties, including the warranty of merchantability, are limited in duration to the period
of this expressed warranty and no warranty whether expressed or implied shall apply to
the product thereafter.

Under no circumstance shall Craig be liable for any loss or consequential damage arising
out of the use of this product. This warranty gives specific legal rights. However, you may
have other rights which may vary from state to state. Some states do not allow limitations
on implied warranties or exclus ion of consequential damage. Therefore, these
restrictions may not apply to you.

To Obtain Service on your Product

email:[e-mail]

LIMITED WARRANTY

Printed in China CHT912-IB-E0FT1-B0US

Meijer.com