OPERATOR’S MANUAL
Door Kit
Please indicate the following information from the service part drawing provided.
Model Number: ____________________________
Model Description: _________________________
*Product you purchased may vary from picture shown.
Caution: Read and follow all Safety Rules and Operating Instructions before first
use of this product. Retain this document for future reference.
Distributed by Sears Brands Management Corporation., Hoffman Estates, IL 60179
F1728
SAFETY
SAFETY WARNINGS AND CAUTIONS:
• Use appropriate safety equipment when using power and hand tools. Failure to do so may cause personal injury or product
damage.
• Use adequate manpower when assembling and moving this unit. Failure to do so may cause personal injury or product
damage.
• DO NOT stand on this product. You may fall which m ay cause personal injury.
• DO NOT mount this product on a truck bed or any other moving object. This may cause personal injury or product damage.
• Appropriately secure this product before moving it with a forklift.
• DO NOT alter this product in any m anner. For example, do not weld external lockbars or attach electrical equipm ent. This
may cause product dam age or personal injury.
• Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface,
which may cause personal injury or product damage.
Tools Required:
Socket wrench
7/16" socket
11/32" wrench
Screwdriver, crosstip
Screwdriver, flathead
Square
Hardware Included
Call 1-800-4MY-HOME (1-800-469-4663) for Service Parts.
Refer to Service Parts Drawing for full listing of Service Parts.
2
ASSEMBLY
• Attach F, as shown, using (2) DD.
STEP (1):
AA(4)
BB(4)
CC(4)
Note: Door kit may be installed on left or right side. Installation
shown on right side.
• Move workbench away from any walls to gain access to the
back of the unit.
• Remove the necessary hardware securing the upper rail. The
top rail does NOT need to be removed completely, just the
lower hardware removed.
• The bottom rail needs to be removed completely so the back
panel B can be installed behind the lower rail.
CC
AA
BB
Workbench Top
removed for clarity
F
DD
STEP (3):
AA(2)
B
• Secure Back panel B with (4) AA, (4) BB and (4) CC.
• Secure bottom rail with original fasteners.
STEP (2):
DD (2)
FF
BB(2)
CC(2)
• Remove top front rail and bottom rail from workbench.
• Attach door A through hinge (which is welded to door) using
(2) AA, (2) BB and (2) CC.
• Be sure to use the lower mounting hole on top rail and upper
hole in bottom rail as shown below.
• Re-attach front rails using existing hardware.
Door removed for
clarity
AA
3
A