Instruction Manual
1.4 cu.in./21cc 2-Cycle
16 Inch Cutting Path / .065 In. Line
GASOLINE WEEDWACKER ®
Model No.
C944.517361
• Safety
• Assembly
• Operation
• Maintenance
• Parts List
• Fran_;ais
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions about this product:
Call 7 am-7 pm, Mon.-Sat., or 10 am-7 pm, Sun.
1-800-235-5878 l,ours listed are Centra, T,me)
Sears Canada, Inc., Toronto, Ontario M5B 2B8
530163407 10]15/02
Warranty Statement 2 Storage 10
Safety Rules 2 Troubleshooting Table 11
Assembly 4 Emissions Statement 12
Operation 5 Parts List 14
Maintenance 8 French 16
Service & Adjustments 9 Parts and Ordering Back
LIMITED TWO (2) YEAR WARRANTY ON CRAFTSMAN GAS WEEDWACKER
For two (2) years from the date of purchase, Sears Canada, Inc., will repair or
replace free of charge at Sears option parts which are defective as a result of
material or workmanship.
COMMERCIAL OR RENTAL USE:
Warranty on Gas Weedwacker will be 90 days from the date of purchase if used
for commercial or rental purposes.
This warranty does not cover:
1. Spark plugs, filter, line, spool, starter rope, and blade.
2. Damages to the motor of the unit when operated without the proper fuel
mixture (see manual).
Warranty service is available by returning the Weedwacker to the nearest Sears Ser-
vice Center/Department in Canada. This warranty applies only while this product is in
use in Canada.
This warranty is in addition to any statutory warranty and does not exclude or limit
legal rights you may have but shall run concurrently with applicable provincial
legislation. Furthermore, some provinces do NOT allow limitations on how long an
implied warranty will last, so the above limitations may not apply to you.
Sears Canada, Inc,, Toronto, Ontario MSB 2B8
_,WARNING: When using gar-
dening appliances, basic safety pre-
cautions must always be followed to
reduce the risk of fire and serious
injury. Read and follow all instructions.
This power unit can be dangerous!
Operator is responsible for following
instructions and warnings on unit and
in manual, Read entire instruction
manual before using unit! Be thor-
oughly familiar with the controls and
the proper use of the unit. Restrict the
use of this unit to persons who have
read, understand, and will follow the
instructions and warnings on the unit
and in the manual. Never allow chil-
dren to operate this unit.
iNSTRUCTION SAFETY INFORMATION
MANUAL ON THE UNIT
J
DANGER: Never use blades or
flailing devices. This unit is designed
for line trimmer use only. Use of any
other accessories or attachments will
increase the risk of injury.
@00
,_ WARNING: Trimmer line throws
objects violently. You and others can
be blindedlinjured. Wear eye and leg
protection. Keep body parts clear of
rotating line.
_ Protection
_ _oots
2
Keep children, bystanders, and ani-
mals 50 feet (15 m) away. If ap-
proached, stop unit immediately.
If situations occur which are not cov-
ered in this manual, use care and
good judgement. If you need assis-
tance, contact Sears Service or call
1-800-235-5878.
OPERATOR SAFETY
• Dress properly. Always wear safety
glasses or similar eye protection when
operating, or performing maintenance,
on your unit (safety glasses are avail-
able). Eye protection should be
marked Z87.
• Always wear face or dust mask if op-
eration is dusty.
• Always wear heavy, long pants, long
sleeves, boots, and gloves. Wearing
safety leg guards is recommended.
• Always wear foot protection. Do not
go barefoot or wear sandals. Stay
clear of spinning line.
• Secure hair above shoulder length.
Secure or remove loose clothing or
clothing with loosely hanging ties,
straps, tassels, etc. They can be
caught in moving parts.
• Being fully covered also helps protect
you from debris and pieces of toxic
plants thrown by spinning line.
• Stay Alert. Do not operate this unit
when you are tired, ill, upset or under
the influence of alcohol, drugs, or
medication. Watch what you are do-
ing; use common sense.
• Wear hearing protection.
• Never start or run inside a closed
room or building. Breathing exhaust
fumes can kill.
• Keep handles free of oil and fuel.
UNIT / MAINTENANCE SAFETY
• Disconnect the spark plug before
performing maintenance (except
carburetor adjustments).
• Look for and replace damaged or
loose parts before each use. Look
for and repair fuel leaks before use.
Keep in good working condition.
• Replace trimmer head parts that are
chipped, cracked, broken, or dam-
aged in any other way before using
the unit.
• Maintain unit according to recom-
mended procedures. Keep cutting
line at proper length.
• Use only 0.065" (1.65 ram) diameter
Craftsman brand line. Never use
wire, rope, string, etc.
• Install required shield properly be-
fore using the unit. Use only speci-
fled trimmer head; make sure it is
properly installed and securely fas-
tened.
• Make sure unit is assembled cor-
rectly as shown in this manual.
• Make carburetor adjustments with
lower end supported to prevent line
from contacting any object.
• Keep others away when making car-
buretor adjustments.
• Use only recommended Craftsman
accessories and replacement parts.
• Have all maintenance and service
not explained in this manual per-
formed by a Sears Service Centre.
FUEL SAFETY
• Mix and pour fuel outdoors.
• Keep away from sparks or flames.
• Use a container approved for fuel.
• Do not smoke or allow smoking near
fuel or the unit.
• Avoid spilling fuel or oil. Wipe up all
fuel spills.
• Move at least 10 feet (3 meters)
away from fueling site before start-
ing engine.
• Stop engine and allow to cool before
removing fuel cap.
• Always store gasoline in a container
approved for flammable liquids.
CUTTING SAFETY
,d_ WARNING: Inspect the area be-
fore each use. Remove objects
(rocks, broken glass, nails, wire, etc.)
which can be thrown by or become
entangled in line. Hard objects can
damage the trimmer head and be
thrown causing serious injury.
• Use only for trimming, mowing and
sweeping. Do not use for edging,
pruning or hedge trimming.
• Keep firm footing and balance. Do
not overreach.
• Keep all parts of your body away
from muffler, cutting head and spin-
ning line. Keep engine below waist
level. A hot muffler can cause seri-
ous burns.
• Cut only from your right to your left.
Cutting with the line on left side of
the shield will throw debris away
from the operator.
• Use only in daylight or good artificial
light.
• Use only for jobs explained in this
manual.
TRANSPORTING AND STORAGE
• Allow engine to cool; secure unit be-
fore storing or transporting in ve-
hicle.
3
• Empty the fuel tank before storing or
transporting the unit. Use up fuel left
in the carburetor by starting the en-
gine and letting it run until it stops.
• Store unit and fuel in area where
fuel vapors cannot reach sparks or
open flames from water heaters,
electric motors or switches, fur-
naces, etc.
• Store unit so line limiter cannot acci-
dentally cause injury. The unit can
be hung by the tube.
• Store unit out of reach of children.
SAFETY NOTICE: Exposure to vibra-
tions through prolonged use of gaso-
line powered hand tools could cause
blood vessel or nerve damage in the
fingers, hands, and joints of people
prone to circulation disorders or ab-
normal swellings. Prolonged use in
cold weather has been linked to blood
vessel damage in otherwise healthy
people, If symptoms occur such as
numbness, pain, loss of strength,
change in skin color or texture, or loss
of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An anti-
vibration system does not guarantee
the avoidance of these problems. Us-
ers who operate power tools on a con-
tinual and regular basis must monitor
closely their physical condition and
the condition of this tool.
SPECIAL NOTICE: This unit is not
equipped with a temperature limiting
muffler and spark arresting screen
which meets the requirements of Cali-
fornia Codes 4442 and 4443. All U.S.
forest land and the states of California,
Idaho, Maine, Minnesota, New Jersey,
Oregon, and Washington require by
law that many internal combustion en-
gines be equipped with a spark arres-
tor screen. If you operate in a locale
where such regulations exist, you are
legally responsible for installing and
maintaining the operating condition of
these parts. Failure to do so is a viola-
tion of the law. If a spark arresting
screen is required in your area, con-
tact your Sears Service Centre for the
correct kit.
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model C944.517361
• Trimmer
• Shield
• Container of Oil
Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
It is normal for the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is
normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
,t% _
_IbWARNING: If received as-
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
ADJUSTING THE HANDLE
4fJWARNING: When ad usting the
hand e, be sure t rema ns between
the trigger and the safety label.
1. Loosen wing nut on handle.
2. Rotate the handle on the tube to an
upright position; retighten wing nut.
ATTACHING SHIELD
_WARNING: The shield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOWYOURTRIMMER illustration in OP-
ERATIONsection.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes through
hole in bracket.
4. Securely tighten wing nut onto bolt.
Slot
Shield
Bracket
Wing
Line Limiter Blade
Nut
4